10C of charge flow through a resistor in 4 seconds. What is the current?

Answer:

The greater the amplitude of a wave then the more energy it is carrying.

Explanation:

E is carrying the most energy which means that it has the highest amplitude

A has the least energy because it has the lowest amplitude

Answer:

Atmospheric pressure is caused by the gravitational attraction of the planet on the atmospheric gases above the surface and is a function of the mass of the planet, the radius of the surface, and the amount and composition of the gases and their vertical distribution in the atmosphere

Explanation:

Explanation:

The rod can be in equilibrium only if the resultant force is 0 and the moment around any point of the rod must be equal to 0.

We have to take moments around the pivoted point.

Moment = Force × Perpendicular distance to the force

For the rod to be in equilibrium,

Clockwise moment - Anticlockwise moment = 0

Clockwise moment = Anticlockwise moment

The distance between pivoted point and the weight of rod = 50 cm - 30 cm = 20 cm

So 20 cm× 1.2 N produces a Clockwise moment

If Perpendicular distance between pivoted point and 2N load is x,

Anticlockwise moment = x × 2N

20 cm× 1.2N = 2N × x

x = 12 cm

So 2 N load is at 12 from the pivoted point.

From the left edge of the meter ruler, 2N load is at 30-12 cm distance

= 18 cm

Answer: 18 cm

Explanation:

Answer: yess sirrrrrrrr

Explanation:

Answer:

oou I like it! u did a good job ^^

The frequency of a photon of red light with wavelength 4.50 x 10−7m is 6.67 x 1014Hz.

The largest angle for which box B will not slip​ is 16.7⁰.

The given parameters:

The frictional force between box A and box B is calculated as;

[tex]F_f_1= \mu_s_1 (mg)[/tex]

The frictional force between box B and inclined surface is calculated as;

[tex]F_f = \mu_s_2 (2mg) cos(\theta)[/tex]

The net force on the boxes that results in no movement is calculated as;

[tex](2mg) sin(\theta) - F_f= 0\\\\(2mg) sin(\theta) = F_f\\\\(2mg) sin(\theta) = \ \mu_s_2 (2mg) cos(\theta)\\\\ sin(\theta) = \mu_s_2 cos(\theta)\\\\\mu_s_2 = \frac{sin(\theta)}{cos(\theta)} \\\\\mu_s_2 = tan(\theta)\\\\\theta = tan^{-1} (\mu_s_2)\\\\\theta = tan^{-1} (0.3)\\\\\theta = 16.7 \ ^ 0[/tex]

Thus, the largest angle for which box B will not slip​ is 16.7⁰.

Learn more about coefficient of static friction here: https://brainly.com/question/25050131

Answer: 4.44302176697 m/s^2

Explanation:

formula for acceleration is (final velocity - initial velocity)/time.   So in your case:

(34.7m/s - 0m/s)/ 7.81s  = 4.44302176697 m/s^2

Answer:

116 N•s

Explanation:

change in momentum = mvf-mvi

= m(Vf - Vi)

= 20( 8.1-2.3)

change in momentum= 116 kg•m/s

: .impulse is 116 N•s

The 4th state of matter would make an acceptable force field.

The 4th state of matter which is plasma would make an acceptable force field because this fourth state of matter is present in ionized form which has two charges on it i.e. cation which is a positive charge and anion which is a negative charge.

We know that charges attract as well repel other objects if they are strong enough. Positive charge repel positive charge but attract negative charge so we can conclude that 4th state of matter would make an acceptable force field.

Learn more: https://brainly.com/question/25628398

Answer:

a) F = 84.64N

b) The force has to increase.

Explanation:

First of all, let's convert everything to the same unit system:

Vo = 0 m/s    Vf = 98 mi/h * 1609.34 m / 1mi * 1h / 3600s = 43.8m/s

d = 1.7m         m = 0.15kg

We can calculate force as:

F = m*a    where a is the acceleration experiencd by the ball and m is its mass.

In order to calculate acceleration, we can use this formula:

   Solving for a:

Now, the force will be:

F = m * a = 84.6N

As we can see in that previous equation, the force is directly proportional to the mass of the ball, so, assuming the final speed of the ball is the same as before (that is, the acceleration is the same), the force will increase in the same proportion as the mass does.

Answer:

C.

Explanation:

Answer:

c. Radio and T.V. signals

The magnetic field strength is needed to generate a peak voltage 0.15 T.

The given parameters;

The area of the coil is calculated as follows;

[tex]A = \pi r^2\\\\A = \pi \times 0.09^2\\\\A = 0.0255 \ m^2[/tex]

The maximum emf induced in the coil is calculated as follows;

[tex]E_{max} = NBA \omega \\\\B = \frac{E_{max}}{NA\omega } \\\\[/tex]

where;

[tex]B = \frac{170 }{120 \times 0.025 \times 2\pi \times 60 } \\\\B = 0.15 \ T[/tex]

Thus, the magnetic field strength is needed to generate a peak voltage 0.15 T.

"Your question is not complete, it seems to be missing the following information";

An electric generator has an 18-cm-diameter, 120-turn coil that rotates at 60 hz in a uniform magnetic field that is perpendicular to the rotation axis.

What magnetic field strength is needed to generate a peak voltage of 170 V?

Learn more here:https://brainly.com/question/17238887

Answer:

willie tower

Explanation:

mataas kasi

Answer:

LOL Diagrams

a way to represent how the energy is stored in the chosen system during various snapshots and to represent any changes in total energy for the system. Each “L” represents how the energy is stored during a particular snapshot (instant). The “O” shows the objects inside and outside the system.

Answer:

A Wave red

Explanation:

Answer:

Answer: Wave E

Explanation:

Why because if you put each in a strait line it would have been longer

hope it helps

Explanation:

Spring is stretched by force f to distance

"X"

now here by force balance we can say

f = kx

k = !

now here we will we say that energy stored in the spring will convert into kinetic energy

kx² = mv²

(x² = mv²

now solving above equation we will have

PART 2)

now for half of the extension again we can use energy conservation

ka²-k(x/2)² = 1 {mv²

¾fx=mv²

now the speed is given as

3 fr 4m V=

Answer:

All objects are composed of these atoms. ... Charged objects have an imbalance of charge - either more negative electrons than positive protons or vice versa. And neutral objects have a balance of charge - equal numbers of protons and electrons.

Explanation:

The time spent in the air by the ball at the given momentum is 6.43 s.

The given parameters;

The impulse experienced by the ball is calculated as follows;

[tex]Ft = \Delta P[/tex]

where;

[tex]Ft[/tex] is impulse

[tex]\Delta P[/tex] is change in momentum

The time of motion of the ball is calculated as follows;

[tex]t = \frac{\Delta P}{F} \\\\t = \frac{0.9 - 0}{0.14} \\\\t = 6.43 \ s[/tex]

Thus, the time spent in the air by the ball at the given momentum is 6.43 s.

Learn more here:https://brainly.com/question/13468390

Answer:

(a) 6,000,000J      

(b)  3,000,000J

(c)  For A 20,000W

But for B 10,000W

The work done in getting  the car to the top is equal to 6 ×10⁶ J. If the vertical speed is 2.5 m/s then, the work done will be  3 ×10⁶ J. The power exerted on the car is in 5 minutes is 20000 J/s.

In physics, work done is the dot  product of force and displacement. Let w be the work done and F and ds be the force and displacement. Then

W = F.ds

It is given that the, the force of the cable is 4 × 10³ N. The velocity is 5 m/s and time is 5 minutes or 300 seconds. Now, the displacement is the product of time and velocity.

ds = velocity ×  time

    =  300 s ×  5 m/s

    = 1500 m.

Thus the work done = F × ds

                                  = 4 × 10³ N ×  1500 m

                                  = 6 ×10⁶ J .

If the velocity is reduced to half 2.5 m/s , then work done will be reduced to half as 3 ×10⁶ J.

Power is the rate of work done. Thus it is the ratio of work done to time. The power exerted on the car in 5 minutes = 6 ×10⁶ J /300s

                                                                        = 20000 J/s

Hence, the power exerted on the cable car in 5 minutes is 20000 J/s.

To find more on work done, refer here:

https://brainly.com/question/3902440

#SPJ3

Answer:

The uneven heating results in some of the atmosphere to be warmer than other parts and changes in volume and pressure which result in updrafts and can cause thunderstorms and other violent weather.

Explanation:

Generation of wind

Answer:

a-

V= IR

9V = I ×( 12+6)

I = 9/ 18 A = 0.5 A

b

V=IR

240 = 6 A ×( 20 + R)

40 = 20 + R

R = 20 ohm

c

resultant resistance of the 2 parallel resistances= Ro

1/Ro = 1/ 5 + 1/ 20

1/Ro =( 20+5)/100

= 1/Ro = 1/4

Ro= 4 ohm

V=IR

V = 2A × ( 1+ 4 OHM)

V = 10V

d

equivalent resistance = Ro

1/Ro = 1/(2+8) + 1/(5+5)

1/Ro = 1/10 +1/10

2/10 = 1/ Ro

Ro= 10/2 = 5 ohm

V = IR

12V = I × 5Ohm

I=2.4 A

Answer:

Photons

Explanation:

I just know

Discrete packets of kinetic energy in light are called photons. Photons are fundamental particles of light and electromagnetic radiation. The correct answer is photons.

Photons are fundamental particles of light and electromagnetic radiation. They carry energy in discrete quantities, known as quanta or packets, and exhibit both wave-like and particle-like properties.

The energy of a photon is directly proportional to its frequency, and inversely proportional to its wavelength. When light interacts with matter, it can transfer its energy to the particles it interacts with, leading to various phenomena such as absorption, reflection, and emission.

Therefore, Discrete packets of kinetic energy in light are called photons.

To know more about the photon:

https://brainly.com/question/34096290

#SPJ6

To move maximum height the friction force can be assumed to be

negligible.

Reasons:

The component of the weight acting on the incline, w = m·g·sin(θ)

Length of the ramp = 15 m

Potential energy of the box = 15 × sin(θ) ×20 = 300·sin(θ)

F × 15 = 300·sin(θ)

F = 20·sin(θ)

Work done by net force = Potential energy gained by the box

Work done by net force = (40 - 20·sin(θ)) × 15 = 300·sin(θ)

40 = 20·sin(θ) + 20·sin(θ) = 40·sin(θ)

sin(θ) = 1

θ = arcsin(1) = 90°

The ramp is at an inclination of 90°, therefore, the ramp is oriented vertically

The height of the ramp = The length of the ramp = 15 m

Learn more here about forces acting on an incline plane here:

https://brainly.com/question/23944424

Answer:

velocity ,V=?,T=4hr,Distance ,144km,

V=distance divide by time

=144/4=36km/hr

Answer:

*Disclaimer you can't actually do that, or at least not yet because the nearest black hole is at least 1,000 light years away. But if we could...

His journy would be pretty fast and horrific. For him, he would slowly be streched apart or spegetified into a string of atoms as he nears the event horizoin. But for an outside observer he would apear to go slower and slower and would never actualy reach the event horizion. This is becuase of einstines general relativity, massive objects slow time down. He would also apear to become red as the lights wavelength is streched out due to the entense gravity of the black hole.

Answer:

D. unsaturated fat

Explanation:

Unsaturated fats are considered the healthiest fats because they improve cholesterol, help reduce inflammation (a risk factor for heart disease), and help decrease the overall risk of developing heart disease. The main source of unsaturated fats are plant-based foods.

Answer:unsaturated fat

Explanation: