8. What is the mass of 4.50 x 1022 Cu atoms?​

Answer:

Metals are good conductors of heat. Due to this property metals are used in the preparation of kitchen utensils. Aluminium is good conductor of heat and more over it is corrosion resistent. Due to these properties aluminium is used in making kitchen utensils.

Explanation:

Answer:

They cause boys' and girls' bodies to develop

Answer:

Answer: 882mmHg

Explanation:

In a closed-end manometer, the gas added is under a pressure that is measured against atmospheric pressure. The difference in pressure between both gases is equal to the difference in mercury levels. Thus, the pressure of the argon can be:

783 mmHg - 96.0mmHg = 687mmHg

783 mmHg - 96.0mmHg = 879mmHg

Based on the options, the possible answer (The nearest to the second value) is:

Chemical reactions involve breaking chemical bonds between reactant molecules (particles) and forming new bonds between atoms in product particles (molecules). The number of atoms before and after the chemical change is the same but the number of molecules will change

Answer:

The bonds in reactants break so that elements can rearrange form new products

Explanation:

Given the reaction N2 + 3H2 -->2NH3, what volume of hydrogen is necessary to react with five liters of nitrogen to produce ammonia, assuming constant temperature and pressure? How would you calculate the mass in grams of hydrogen chloride produced when 4.9 L of molecular hydrogen at STP reacts with an excess of chlorine gas.?

Answer:

They are considered nonrenewable because they are prehistoric animals that has been extinct therefore can't be renew.

Answer:

Explanation:

YONG ISA PO ETO HINDI KO PO ALAM TOH

Answer:

eyelashes are not a part of the the human organs

Answer:

Ph = 6.12....

here ya go

Explanation:

-

The pH of the solution with a concentration of 7.6 × [tex]10^{-7}M[/tex] [tex]H_{3}O^{+}[/tex]will be 6.12.

The pH of water indicates how acidic or basic it is. The scale runs from 0 to 14, with 7 representing neutrality. Acidity is indicated by a pH less than 7, while a pH greater than 7 denotes a base. The relative number of free hydrogen, as well as hydroxyl ions in water, and hydroxyl ions in water is measured by pH .

It is known that ,[[tex]H_{3}O^{+}[/tex]]=[tex][H^{+} ][/tex]

pH can be calculated by the formula:

[tex]pH = -logH^{+}.[/tex]

Now, put the value of hydrogen ion in above equation

pH = -log[7.6×10^{-7}M]

      = -log(7.6)-log(10^{-7}

       = -0.88+7log 10

       = -0.88 +7

        = 6.12.

Therefore, the pH of the solution will be 6.12.

To know more about pH click here.

https://brainly.com/question/491373.

#SPJ2

Answer:The answer is c

Explanation:

Answer:

I think that the volume will be 1.414

Explanation:

According to the formula of boyle's law P1 V1 = P2 V2

We have to find V2 so:

V2 = P2/P1 V1

By putting the values:

V2 = 5.06/2.11 * 1.696

V2 = 5.06/3.578

V2 = 1.414

Please give me brainliest, it will mean a lot to me.

Answer:

..............,.,.,.,,..,,.,.,

Answer:

Measure 2.47 mL of the stock solution (i.e 0.0405 mM) and dilute it to the 100 mL mark with water

Explanation:

To make 100 mL of 0.001 mM solution from 0.0405mM solution, we need to determine the volume of 0.0405mM solution needed. This can be obtained as follow:

Molarity of stock (M₁) = 0.0405 mM

Volume of diluted (V₂) = 100 mL

Molarity of diluted solution (M₂) = 0.001 mM

Volume of stock solution needed (V₁) =?

M₁V₁ = M₂V₂

0.0405 × V₁ = 0.001 × 100

0.0405 × V₁ = 0.1

Divide both side by 0.0405

V₁ = 0.1 / 0.0405

V₁ = 2.47 mL

Therefore, to make 100 mL of 0.001 mM solution from 0.0405mM solution, measure 2.47 mL of the stock solution (i.e 0.0405 mM) and dilute it to the 100 mL mark with water.

Answer:

CDE

Explanation:

If your on USA test perp

The questions are most relevant to increasing the strength of the electromagnet are Does increase the current in .....?, Will increasing the number of loops of wire around the.....? and Will positioning the loops of….? Therefore, option C, D and E are correct.

The characteristics known as electromagnetic properties determine how quickly a substance will absorb or emit electromagnetic radiations.

We may be familiar with electromagnetic radiations such as radio waves, microwaves, ultraviolet rays, infrared rays, and visible light rays.

Transverse waves characterize electromagnetic radiation.They move across fluctuating magnetic and electric fields so that they are perpendicular to the wave's path of propagation and at right angles to one other.

Thus, option C, D and E are correct.

To learn more about the properties of electromagnet, follow the link;

https://brainly.com/question/15502579

#SPJ6

Answer:

1. 0.82 gram of Ag+

2. 4.79 g of Ag₂O₃S

Explanation:

From the given information:

Total amount of Ag₂O₃S = 2.24 grams

Atomic mass of Ag+ =107.86 g/mole

molar mass of Ag₂O₃S = 295.8  g/mole

∴

The mass of the Silver (Ag) in grams is:

[tex]= Total\ amount \ of \ Ag^+ \times \dfrac{107.86 \ g/mol}{295.8 \ g/mol}[/tex]

[tex]=2.24 \times \dfrac{107.86 \ g/mol}{295.8 \ g/mol}[/tex]

= 0.82 gram of Ag+

2.

Here, the total amount of Ag₂O₃S = unknown

Atomic mass of Ag+ = 107.86 g/mole

molar mass of Ag₂O₃S = 295.8 g/mole

amount of Ag+  = 1.75 g

∴

The mass of Ag₂O₃S = [tex]Total \ amount \ of \ Ag^+ \times \dfrac{295.8 \ g/mol}{107.86\ g/mol}[/tex]

[tex]=1.75 \times \dfrac{295.8 \ g/mol}{107.86\ g/mol}[/tex]

= 4.79 g of Ag₂O₃S

Answer: The answer is F

The answer is F , F shows the amount of energy the reactants need to gain to become products .

A potential energy diagram shows the change in potential energy of a system as reactants are converted into products.

From the figure attached we can understand the Eₐ is the activation energy reactants need to get converted into products.

Now when we study the figure( potential energy Diagram) given in the question ,

The reactants are energy level shown by G

The total energy required to get converted into products is denoted by H while ,

H - G is the actual energy required which is denoted by F.

Therefore F shows the amount of energy the reactants need to gain to become products .

To know more about Potential Diagram

https://brainly.com/question/12078312

#SPJ2

Answer:

82gS

Explanation:

2 Fe  + 3 S  →  Fe2S3

          ↓      ↑  

       mol → mol

        Fe         S

[tex]\frac{95 g Fe }{} \frac{1 mol Fe }{55.85 g Fe } \frac{3 mol S }{2 mol Fe } \frac{32.07 g S}{1 mol S} = 82 g S[/tex]

Answer:

the molar mass of zinc is 65.38u or 65.38 grams(g).

Answer:

See Explanation

Explanation:

In thermodynamics theory the Free Energy (ΔG) of a chemical system is described by the expression ΔG = ΔG° + RTlnQ. When chemical system is at equilibrium ΔG = 0. Substituting into the system expression gives ...

0 = ΔG° + RTlnKc, which rearranges to ΔG° = - RTlnKc.  ΔG° in electrochemical terms gives ΔG° = - nFE°, where n = charge transfer, F = Faraday Constant = 96,500 amp·sec and E° = Standard Reduction Potential of the electrochemical system of interest.

Substituting into the ΔG° expression above gives

-nFE°(cell) = -RTlnKc => E°(cell) = (-RT/-nF)lnKc = (2.303·R·T/n·F)logKc

=> E°(cell) = (0.0592/n)logKc = E°(Reduction) - E°(Oxidation)

Application example:

Calculate the Kc value for a Zinc/Copper electrochemical cell.

Zn° => Zn⁺² + 2e⁻  ;    E°(Zn) = -0.76 volt  

Cu° => Cu⁺² + 2e⁻ ;    E°(Cu) =  0.34 volt

By natural process, charge transfer occurs from the more negative reduction potential to the more positive reduction potential.

That is,

           Zn° => Zn⁺² + 2e⁻ (Oxidation Rxn)

Cu⁺² + 2e⁻ => Cu°             (Reduction Rxn)

E°(Zn/Cu) = (0.0592/n)logKc

= (0.0592/2)logKc = E°(Cu) - E°(Zn) = 0.34v - (-0.76v) = 1.10v

=> logKc = 2(1.10)/0.0592 = 37.2

=> Kc = 10³⁷°² = 1.45 x 10³⁷

Answer:

a. NO is added to the reaction mixture ⇒ to the left

b. BrNO is added to the reaction mixture ⇒ to the right

c. Br₂ is removed from the reaction mixture ⇒ to the right

d. Pressure is increased ⇒ to the left

Explanation:

The reaction at equilibrium is the following:

2BrNO (g) → 2NO (g)+ Br₂ (g)

The left side is the reactants side (2 BrNO) and the right side is the products side (2 NO + Br₂).

a. NO is added to the reaction mixture

NO is a product, in the right side of the equation. If a product is added, the equilibrium will shift to the opposite side, to the left, to form more reactants and compensate for the addition.

b. BrNO is added to the reaction mixture

BrNO is a reactant, in the left side of the equation. If a reactant is added to a reaction at equilibrium, more product will be formed in compensation. Therefore, the equilibrium will shift to the right.

c. Br₂ is removed from the reaction mixture

Br₂ is a product, in the right side. If it is removed, the system will compensate for the remotion by forming more product, so the reaction will shift to the right.

d. Pressure is increased

Since both reactants and products are in the gas phase, the equilibrium is affected by pressure. If pressure is increased, the equilibrium will shift to the side of the reaction with the fewest number of moles. The reactants side (left) has 2 moles of BrNO while the products side (right) has 3 moles (1 mol NO + 1 mol Br₂ = 3 moles of gas). Therefore, the reactants side has the fewest number of moles, so the equilibrium will shift to the left.

Answer:

it's a covalent linkage in which two atoms share three pairs of electrons as in nitrogen molecule or acetylene

Answer:

See Explanation

Explanation:

The reaction equation is

3H2(g) + N2(g) -----> 2NH3(g)

1)If 1 mole of N2 yields 2 moles of NH3

12 moles of N2 will yield 12 * 2/1 = 24 moles of NH3

2) 3 moles of nitrogen reacts with 1 mole of nitrogen

6 moles of hydrogen will react with 6 * 1/3 = 2 moles of nitrogen

3) The limiting reactant yields the least amount of product

If 1 mole of nitrogen yields 2 moles of NH3

40 moles of nitrogen yields 40 * 2/1 = 80 moles of NH3

If 3 moles of hydrogen yields 2 moles of NH3

30 moles of hydrogen yields 30 * 2/3 = 20 moles of NH3

Hence hydrogen is the limiting reactant

4) Number of moles in 80g of NH3 = 80g/17g/mol = 4.71 moles

3 moles of hydrogen produces 2 moles of ammonia

x moles of hydrogen produces 4.71 moles of ammonia

x = 3 * 4.71/2 = 7.065 moles of hydrogen

Mass = 7.065 moles of hydrogen * 2 g/mol

Mass = 14.13 g of hydrogen

Answer: A. Elements with intermediate numbers of valence electrons are the least reactive.

Explanation: I Quizzed

Answer:

convection

hope this helps

have a good day :)

Explanation:

Answer:

a)

Explanation:

Osmosis is a process in which there is movement of solvent molecules through a semipermeable membrane to wards the higher concentration of solute or lower concentration of solvent from a lower concentration of solute molecule. Osmosis can occur in different liquids and even in gases.

Also, in osmosis knowing the osmotic pressure can help determine the molar mass of a solute dissolved in a solvent.

Answer:

True

Explanation:

Answer:

the rate at which reactants form products is the same as the rate at which products form reactants

Explanation:

There is still  a reaction happening just that the second one happens the opposite happens and keeps it at net 0