A load uses a current of 5.0 A when it is attached to a 20 V source. What is the resistance of the load?

Answer:

“The Tyger” represents the evil and beauty too, “the forest of the night” represents unknown challenges, “the blacksmith” represents the creator and “the fearful symmetry” symbolizes the existence of both good and evil. Imagery: Imagery is used to make the readers perceive things with their five senses.

Explanation:

Answer:

gamma rays are super compact

Explanation:

as you move up the electromagnetic spectrum the wave lengths get shorter and shorter (higher and higher energy) gammas being the highest on the spectrum

Radio waves pass through us easily every day with no bad effects. Gamma Rays will kill you in large doses. the difference between these two forms of waves are in their energy.

Wave is is a disturbance in a medium that carries energy as well as momentum . wave is characterized by amplitude, wavelength and phase. Amplitude is the greatest distance that the particles are vibrating. especially a sound or radio wave, moves up and down. Amplitude is a measure of loudness of a sound wave. More amplitude means more loud is the sound wave.

Wavelength is the distance between two points on the wave which are in same phase. Phase is the position of a wave at a point at time t on a waveform.

There are two types of the wave longitudinal wave and transverse wave.

The energy of the electromagnetic photon is given by frequency times plank's constant. Hence energy is directly proportional to the requency. The frequency of the radio waves is far smaller than the gamma rays hence it has low energy. this is the difference, which leads gammas rays  injurious to heath.

To know more about Electromagnetic wave :

https://brainly.com/question/3101711

#SPJ2.

Answer:

See Explanation

Explanation:

We know that;

P= IV

Where;

P = power

I= current

V = voltage

Here, we have a voltage of 220V

Hence, for maximum rate;

P= IV

I = P/V

P = 840 W

V= 220 V

I= 840 W/220 V

I= 3.8 A

V = IR

R = V/I

R = 220/3.8

R = 57.9 Ω

For minimum heating;

P= 360 W

V= 220 V

I = P/V

I = 360 W/220V

I= 1.6 A

V= IR

R = V/I

R = 220 V/1.6 A

R = 137.5 Ω

Answer:

Its False

Explanation:

In parallel circuits the current splits up so each branch has a different effective resistance (in each of the separate branches one can use the series rule again). Due to this, the current isn't the same everywhere in a parallel circuit.

brainliest?

Answer:

please give me brainlist and follow

Explanation:

In electronics, a voltage divider (also known as a potential divider) is a passive linear circuit that produces an output voltage (Vout) that is a fraction of its input voltage (Vin). Voltage division is the result of distributing the input voltage among the components of the divider.

Answer:

Energy can be transferred from one storage mechanism to another.

Answer:

the  spring constant is -89.2857 n/m

Explanation:

The computation of the spring constant is shown below:

As we know that

Force in newtons = Spring constant × amount of extension

F = -k × x

where

F = 25 N

And, x = 0.280m

So, the spring constant would 2  

= 25N ÷ 0.280 m

= -89.2857 n/m

Hence the  spring constant is -89.2857 n/m

Answer:

genshin impact. the same level. and AdCap

Answer: However, it is not resourceful enough to replace more than a minor amount of the Earth's energy needs. Drilling through the Earth to reach areas hot enough to create steam is possible, but very expensive and difficult. .

Explanation:

Answer:

the answer is radioactive dating

Answer:

They become the same exact tempature

Explanation:

Since they got connected it should be the same.

the temperature of the front pipe compare with the temperature of the back pipe before the pipes touch by using same temperature.

Temperature is the measure of hotness or coldness expressed in terms of any of several arbitrary scales and it indicate the direction in which heat energy will spontaneously flow from a hotter body to a colder body.

It is not the equivalent of the energy of a thermodynamic system like burning match is at a much higher temperature than an iceberg whereas the total heat energy contained in an iceberg.

Temperature which is similar to pressure or density known as intensive property  that is independent of the quantity of matter is considered as distinguished from extensive properties, such as mass or volume.

For more details regarding temperature, visit

https://brainly.com/question/23411503

#SPJ2

Answer:

The circumference of a circle is the distance around it (linear) while a period is the completion of a cycle or the length from one peak to the next of a periodic function

Explanation:

Circumference is the distance around a circle while period is the time taken for one revolution around the circle.

This is a round plane figure whose points are equidistant from a fixed point. The circumference is total distance round the circle.

On the other hand, period refers to the time taken for one revolution around the circle.

Read more about Circle here https://brainly.com/question/10645610

Answer:

Given that - R = 6 ohm

V = 3 volt

n = ?

so by ohms law , V = I X R

I = V \ R = 3 \ 6 = 0.5 A

we know that I = Q / T here t is 1 sec

Q = I X T = 0.5 X 1 = 0.5 C

By the law of quantization ,

Q = n x e

n = Q / e = 0.5 / 1.6 x 10 ^-19

n = 0.3125 x 10^19

hoped so u got the answer mark me as brainellist :)

Answer:

0.5/1.6×10^-19

Explanation:

formula for current is v

I R

3/6=0.5

charge if found by the product of current and time which is one second

0.5×1 =0.5

deficiency of n=no of charges×charge of electrons

0.5/1.6×10^-19

Answer:

B

Explanation:

They are all one-dimensional

Answer:

The subunits of nucleic acids are also the subunits of proteins.

Explanation:

i hope this helps

Answer:

aye son yall think if i keep answering these questions incorrectly.. they'll find out what im doing and take my li points back?

Explanation:

Answer:

The biological material used to determine a DNA profile include blood, semen, saliva, urine, feces, hair, teeth, bone, tissue and cells.

Explanation:

Answer:

bone

Explanation:

Answer:

Yes you are right

Explanation:

hope this helps and I get the Brain thingy whatever it call

Answer:

First

Explanation:

i took the test and its first

The power used when a 100 N force is applied to move an object through a distance of 5 m at constant speed in 10 seconds is 50 W

We'll begin by calculating the energy. This can be obtained as follow:

Force (F) = 100 N

Distance (s) = 5 m

E = F × s

E = 100 × 5

Finally, we shall determine the power. This can be obtained as follow:

Energy (E) = 500 J

Time (t) = 10 s

[tex]P = \frac{E}{t}\\\\P = \frac{500}{10}[/tex]

Therefore, the power used in moving the object is 50 W.

Learn more:

https://brainly.com/question/24817638

Answer: C. -1.16 meters/second2

Explanation:

A= v/t (velocity/time)

in this case: v=7 and t=6

So, A= 7/6

A=1.16

The graph is decreasing so accelleration would be negative

A= -1.16 meters/second2

Option C! ; )

Answer:

-1.16 meters second^2

Explanation:

I got 100% on my test

Answer:

281 Hz

Explanation:

I am so so sorry if this is wrong. But good luck and have a good day

Answer:

Workdone = 17482.36 Joules

Explanation:

Given the following data;

Force, F = 120 N

Angle, d = 28.0°

Distance, x = 165 m

To find the work done, we would use the following formula;

Workdone = FxCosd

Substituting into the formula, we have;

Workdone = 120*165*Cos(28)

Workdone = 19800 * 0.8830

Workdone = 17482.36 Joules

Answer:

The solution of the given query is explained below in the explanation portion.

Explanation:

Given value is:

Work,

⇒  [tex]W=4.30\times 10^3 \ J[/tex]

(a)

The change in the internal energy will be:

⇒  [tex]\Delta V=\frac{3}{2}nR(\Delta T)[/tex]

Throughout the isothermal procedure, The temperature will be constant "ΔT = 0".

then,

⇒  [tex]\Delta V = \frac{3}{2}nR(0)[/tex]

⇒  [tex]\Delta V = 0 \ J[/tex]

(b)

As we know,

⇒  [tex]\Delta V = Q-W[/tex]

On substituting the value, we get

⇒      [tex]0=Q-W[/tex]

On adding W both sides, we get

⇒    [tex]W=Q-W+W[/tex]

⇒    [tex]W=Q[/tex]

On substituting the given value of "W", we get

⇒     [tex]Q=4.30\times 10^3 \ J[/tex]    

Answer:

6 watts

Explanation:

hours against watts

I'm not sure though

Answer:

the car is worth $2,400

Explanation:

6000*15%=900

900*4=3600

6000-3600=2400

the color of light is called reflection

Answer:

Explanation:

1. Both are refracted light.

2. B has more speed.

3. Dispersion

4. Lights of different wavelengths have different speed in prism. It causes the lights to refract at different angle; forming a color spectrum.