A roller coaster speeds up with constant acceleration for 2.3\,\text{s}2.3s2, point, 3, start text, s, end text until it reaches a velocity of 35\,\dfrac{\text{m}}{\text{s}}35
s
m
​
35, start fraction, start text, m, end text, divided by, start text, s, end text, end fraction over 41\,\text{m}41m41, start text, m, end text. We want to find the initial velocity of the roller coaster before it started to accelerate.
Which kinematic formula would be most useful to solve for the target unknown?

Answer:

Explanation:

Power of the heater = P watt .

P x .5 = 1200

P = 2400 W

If resistance of heater R

V² / R = 2400

120²/ R = 2400

R = 6 ohm .

heat to be produced = 99000 J

Current be I

I²R t  x .99 = 99000

20² x 6 x t x .99 = 99000

t = 41.67 s

Answer:

Explanation:

it can be a gas like carbon dioxide in soda

it can be liquid like alcohol in water

it can be solid like sugar and salt

Answer

✔ all three states

Explanation:

TOOK THE TEST

Answer:

it is 45

Explanation:

Answer:

16 m/s sir

Explanation:

because i am in collage

Answer:

velocity and mass

Explanation:

:) apek

Answer:

3.56g

Explanation:

You would use the formula F= ma

F= 89N

A= 25m/s^2

M=?

89= 25*m

Answer:

A) Kinetic energy and gravitational energy

Explanation:

The blimp has kinetic energy, because it is moving. When it circles the event, it gains and uses kinetic energy. It also has potential energy because it has the potential to go a lot faster, and because it has so much stored energy and pressure.

Hope this helps!

Answer:

There is 8900N of force on the rope and team B wins

Explanation:

By listening for it underwater, using SONAR.

Hope this helped!

Answer:

There are seven base SI units corresponding to different parameters and are considered independent of each other. Derived units are derived from these 7 base units. Derived units are dependent on the base units and are not independent of each other. For example, let us derive the SI units for force. By Newtons Second Law of Motion, the force is same as the product of mass and acceleration of a body. that is, force = mass x acceleration. Also, acceleration is defined as the rate of change of velocity. And velocity is defined as the rate of change of displacement. Thus, force = mass x acceleration = mass x dv/dt = mass x dt2 Mass has SI units of kg, distance is measured in m and t has the SI unit of second. Thus, Sl unit of force is kg.m/s^2 (also known as Newton).

Answer:

at rest because time is passing and speed is still at 0

Explanation:

Answer:

0.8N

Explanation:

your welcome:)

Answer:

The car takes 7 seconds to speed up and get out of the way

Explanation:

Constant Acceleration Motion

It's a type of motion in which the velocity of an object changes uniformly over time.

Having a as the constant acceleration, vo the initial speed, vf the final speed, and t the time, the following relation applies:

v_f=v_o+at

Using the above equation we can solve for t:

[tex]\displaystyle t=\frac{v_f-v_o}{a}[/tex]

The car has an initial speed of vo=25 m/s and ends up at vf=60 m/s with an acceleration of a=5 [tex]m/s^2[/tex].

Given all the appropriate data, calculate t:

[tex]\displaystyle t=\frac{60-25}{5}[/tex]

Calculating:

[tex]\displaystyle t=\frac{35}{5}[/tex]

t = 7 seconds

The car takes 7 seconds to speed up and get out of the way

Answer:

T = 0.009 s

Explanation:

It is given that, an OC makes about 112 full wing swings in one second. We need to find the oscillation period of the wasp's wings.

No of oscillations per unit time is called the frequency of an object. It means 112 is the frequency of wing swings. Let T is the oscillation period. It is equal to the reciprocal of frequency as follows :

[tex]T=\dfrac{1}{f}\\\\T=\dfrac{1}{112}\\\\= 0.00892\ s\\\\=0.009\ s[/tex]

Hence, the oscillation period is 0.009 s.

Answer:

When the piston is pulled up, air gets sucked into the pump through the inlet. The pump chamber depressurizes as it fills with air. When the piston is forced down, the air becomes compressed and closes the inlet. Then the air flows out from the outlet

Answer:

100.008 km/h

Explanation:

multiply the speed value by 3.6

Answer:

idek to be honest

Explanation:

Answer: nah

Explanation:

A wet lab experiment for Coulomb's law involves measuring the force between charged objects immersed in a liquid. The experiment is called a "wet" lab because it involves liquid or aqueous solutions.

Coulomb's law is an equation that describes the electrostatic force between two charged particles.

It states that "the force is directly proportional to the product of the charges and inversely proportional to the square of the distance between them."

The equation is given by:

F = k×(q₁ × q₂) / r²

Where

F = the electrostatic force,

k =Coulomb's constant,

q₁ and q₂= the charges of the particles,

r =the distance between the.

In this question,

In the experiment, two conductive objects are charged with opposite charges using a high-voltage power supply, which can be controlled to vary the magnitude of the charges.

The two objects are then immersed in a non-conductive liquid, such as oil or water, and positioned a fixed distance apart.

Using a force sensor or a balance, the force between the two objects is measured as they move toward each other. By measuring the force at different distances, the experiment can verify Coulomb's law, which predicts that the force between two charged objects is proportional to the product of their charges and inversely proportional to the square of their separation distance.

The experiment can be performed with different pairs of charged objects with different magnitudes of charge and separation distances, allowing the relationship between the force and these variables to be investigated. This provides insight into the electrostatic interaction between charged objects in a liquid, which has applications in various fields, including electrochemistry, material science, and biophysics.

Therefore, in a wet lab experiment on Coulomb's law, we have to immerse the apparatus in aqueous solutions.

To learn more about Coulomb's law click:

https://brainly.com/question/506926

#SPJ7

Answer:

d

Explanation:

Answer:

Explanation:

compressions and rarefactions

Answer:

Compressions

-and-

Rarefactions

Explanation:

Answer

m/s rate of change of dispalcement per sec. ie velocity

m/s^2 is (m/s)/s ie rate of change of velocity per sec. ie accelerationplanation:

Answer:

Hi there. I hope your having an amazing day. Here is the answer to you question. Give me brainlest please!

Explanation:

m/s rate of change of displacement per sec. ie velocity

m/s^2 is (m/s)/s ie rate of change of velocity per sec. ie acceleration plantation

Given :

A rectangular solid box of aluminum is heated.

To Find :

Which of the following is not true.

A) Its mass remains constant

C) its density increase

B) Its volume increase

D) none of the above​

Solution :

We know, when an object is heated it expands.

Objects expands means that the volume increases but mass remains same by conservation of mass.

Since mass remains constant and volume increases.

So, density will decrease.

Hence, this is the required solution.

Answer:

128.205.1

Explanation:

The potential energy of a rock that weighs 10.0 kg and is sitting on top of a hill 300 meters high is 29400J

POTENTIAL ENERGY:

P.E = m.g.h

Where;

m = mass of the rock

g = gravitational force of Earth (9.8m/s²)

h = height (m)

P.E = 10 × 9.8 × 300

P.E = 29400J

Learn more: https://brainly.com/question/15613166?referrer=searchResults

Answer:200 5 -20 = v=323

Explanation:

Answer:

I'm not positive but I think the answer is Yes, because both scientific laws and theories are based on evidence.

Explanation:

Sorry I don't have notes on this, hope this helps! :)

Answer:

a and d

Explanation:

a because a nuclear engineer is more on explosions which links to chemistry and d because Gardner is irrelevant