HELP PLEASE WILL MARK BRAINLIEST

Outside wooden steps may get slippery when they are wet. How could you make them less slippery?

Answer:

inertia   .

because yes

Answer:

bro what.

Explanation:

... is this an actual physics question?

Answer:

19.3m/s

Explanation:

Use third equation of motion

[tex]v^2-u^2=2gh[/tex]

where v is the velocity at halfway, u is the initial velocity, g is gravity (9.81m/s^2) and h is the height at which you'd want to find the velocity

insert values to get answer

[tex]v^2-0^2=2(9.81m/s^2)(38/2)\\v^2=9.81m/s^2 *38\\v^2=372.78\\v=\sqrt[]{372.78} \\v=19.3m/s[/tex]

σ = F/A = F/ (πD²/4) = 20000 / (π0.10²/4) = 2.55 MN/m²

The final position of the object after 2 s is 11 m.

Motion: This can be defined as the change in position of a body.

⇒ Formula:

⇒ Where:

From the question,

⇒ Given:

⇒ Substitute these values into equation 1

Hence, The final position of the object after 2 s is 11 m

Learn more about motion here: https://brainly.com/question/15531840

Answer:

There always is an acceleration in a curvilinear motion, as the velocity vector changes, so always.

Answer:D

Explanation:

R =  

V

I

=  

120 volt

0.8 ampere

=  150 ohm (Ω)

P =  V × I

=  120 volt × 0.8 ampere

=  96 watt (W)

An electric light installation  can draw Power of 96 Watt  at 120 V if it creates a current of 0.8 amps

Electric power  is the rate of electric energy transfer by an electric circuit per unit time . It is denoted by P and measured using the SI unit of power that is Watt (W)

since, Electric Power   = voltage * current

Power    = 120 V * 0.8 A

Power    = 96 Watts

An electric light installation  can draw Power of 96 Watt  at 120 V if it creates a current of 0.8 amps

learn more about Electric power  

https://brainly.com/question/16925887?referrer=searchResults

#SPJ3

All the three concurrent forces acting on a body will not produce equilibrium.

The given parameters:

1. 1 N, 3 N and 5 N

2. 2N, 2N and 2 N

3. 3N, 4N and 5 N

4. 4N, 4N and 5 N

Concurrent forces lie on the same plane and their line of action pass through a common point.

A body under concurrent forces is in equilibrium if the resultant of the forces on the body is zero.

[tex]\Sigma F = 0\\\\F_1 + F_2 + F_3 = 0\\\\F_1 + F_ 2 = - F_3[/tex]

where;

[tex]F_3[/tex] is the equilibrant force

First set of concurrent forces;

[tex]1 \ N \ + \ 3\ N = 4 \ N\\\\F_ 3 = 5 \ N\\\\5 \ N > 4 \ N[/tex]

Second set of concurrent forces;

[tex]2 \ N \ + \ 2 \ N = 4 \ N\\\\F_ 3 = 2 \ N\\\\4 \ N > 2 \ N[/tex]

Third set of concurrent forces;

[tex]3 \ N \ + \ 4 \ N = 7 \ N\\\\F_ 3 = 5 \ N\\\\7 \ N > 5 \ N[/tex]

Fourth set of concurrent forces;

[tex]4 \ N \ + \ 4 \ N = 8 \ N\\\\F_ 3 = 5 \ N\\\\8 \ N > 5 \ N[/tex]

Thus, we can conclude that all the three concurrent forces acting on a body will not produce equilibrium.

Learn more about concurrent forces here: https://brainly.com/question/20165540

Answer:

Explanation:

The net work will change the kinetic energy

W = ½mv² = ½m(at)² = ½ma²t²

W = ½(7.7)2.6²(18.5²) = 8907.3985 = 89 kJ

Answer:

Forces can be divided into primarily into two types of forces:

Explanation:

Blood Type O AB

Probability 0.45 0.04

Answer:

its keeps the fur straight.....im kinda confused with the question

Explanation:

Answer:

17.5 N

Explanation:

→ F = (2.5 × 7.0) N

→ F = 25/10 × 7 N

→ F = 5/2 × 7 N

→ F = (5 × 7)/2 N

→ F = 35/2 N

→ F = 17.5 N towards left

Hence, 17.5 N of net force must act on the book to make it accelerate to the left.

Answer:

Explanation:

Q1) d) A is not correct; R is correct (sort of) but is not the reason for A.

A vector may be resolved into an infinite number of components.

Breaking a projectile motion into the vertical and horizontal components is the EASIEST way to solve it because acceleration can be assumed to be constant in both directions. Zero for horizontal and g(ravity) in the vertical. However it is not the ONLY way to do it. Other ways are much more complex.

Q2) a) Both A and R are correct; R is the correct explanation of A  (sort of)

A is correct. Speed is constant in uniform circular motion.

R is correct if you call CENTRIPETAL acceleration constant. It is only constant in magnitude. The direction is always changing as the vector always points toward the center of rotation.

Answer:

A roller coasters accelerates from an initial velocity of of 6.0 m/s to a final velocity of 70 m/s over 4 seconds. What's the acceleration? Q. Acceleration only takes place when things speed up. Q. A drag racer accelerated from 0 m/s to 200 m/s in 5 s.

Explanation:

An LED is useful because when a current passes through it, it gives out light.

An LED is useful because when a current passes through it, it gives out Light.

LED, in full light-emitting diode, in electronics, a semiconductor device that emits infrared or visible light when charged with an electric current.

A light-emitting diode (LED) emits light by applying a forward current to the pn junction of a compound semiconductor.

When forward current is passed through the light-emitting diode, carriers (electrons and holes) move. The holes in the p-type region move to the n-type region and the electrons in the n-type region move to the p-type region. The injected carriers recombine, and the energy difference before and after recombination is released as light. The emitted light depends on the energy band gap (Eg) of the compound semiconductor.

Learn more about light-emitting diode

https://brainly.com/question/12286583?referrer=searchResults

#SPJ2

Explanation:

this is the answer to the questions

Four regions of the electromagnetic spectrum that astronomers use when observing objects in the space are the following enumerated answers.

1. First is Ultraviolet

2. Next is Infrared

3. Then the radio

4. Lastly the Visible lights.

These are the answers to the problem.

Answer:

Transverse waves oscillate perpendicular to the direction of the wave (e.g. any electromagnetic wave like radiowaves, x-rays...) whilst compressional waves oscillate in the same direction of the wave (e.g. sound waves)

Explanation:

Answer:

Change in velocity is the integral of all the differential accelerations acting over the period of acceleration.

[tex]20 = u + \int\limits^4_0 {2t} \, dt[/tex]

20 = u + t²[tex]\left \{ {{4} \atop {0}} \right.[/tex]

20 = u + 4² - 0²

20 = u + 16

u = 4 m/s

Hi there!

a.

We can use the initial conditions to solve for w₀.

It is given that:

[tex]\frac{d\theta}{dt} = w_0e^{-\sigma t}[/tex]

We are given that at t = 0, ω =  3.7 rad/sec. We can plug this into the equation:

[tex]\omega(0)= \omega_0e^{-\sigma (0)}\\\\3.7 = \omega_0 (1)\\\\\omega_0 = \boxed{3.7 rad/sec}[/tex]

Now, we can solve for sigma using the other given condition:

[tex]2 = 3.7e^{-\sigma (8.6)}\\\\.541 = e^{-\sigma (8.6)}\\\\ln(.541) = -\sigma (8.6)\\\\\sigma = \frac{ln(.541)}{-8.6} = \boxed{0.0714s^{-1}}[/tex]

b.

The angular acceleration is the DERIVATIVE of the angular velocity function, so:

[tex]\alpha(t) = \frac{d\omega}{dt} = -\sigma\omega_0e^{-\sigma t}\\\\\alpha(t) = -(0.0714)(3.7)e^{-(0.0714) (3)}\\\\\alpha(t) = \boxed{-0.213 rad\sec^2}[/tex]

c.

The angular displacement is the INTEGRAL of the angular velocity function.

[tex]\theta (t) = \int\limits^{t_2}_{t_1} {\omega(t)} \, dt\\\\\theta(t) = \int\limits^{2.5}_{0} {\omega_0e^{-\sigma t}dt\\\\[/tex]

[tex]\theta(t) = -\frac{\omega_0}{\sigma}e^{-\sigma t}\left \| {{t_2=2.5} \atop {t_1=0}} \right.[/tex]

[tex]\theta = -\frac{3.7}{0.0714}e^{-0.0714 t}\left \| {{t_2=2.5} \atop {t_1=0}} \right. \\\\\theta= -\frac{3.7}{0.0714}e^{-0.0714 (2.5)} + \frac{3.7}{0.0714}e^{-0.0714 (0)}[/tex]

[tex]\theta = 8.471 rad[/tex]

Convert this to rev:

[tex]8.471 rad * \frac{1 rev}{2\pi rad} = \boxed{1.348 rev}[/tex]

d.

We can begin by solving for the time necessary for the angular speed to reach 0 rad/sec.

[tex]0 = 3.7e^{-0.0714t}\\\\t = \infty[/tex]

Evaluate the improper integral:

[tex]\theta = \int\limits^{\infty}_{0} {\omega_0e^{-\sigma t}dt\\\\[/tex]

[tex]\lim_{a \to \infty} \theta = -\frac{\omega_0}{\sigma}e^{-\sigma t}\left \| {{t_2=a} \atop {t_1=0}} \right.[/tex]

[tex]\lim_{a \to \infty} \theta = -\frac{3.7}{0.0714}e^{-0.0714a} + \frac{3.7}{0.0714}e^{-0.0714(0)}\\\\ \lim_{a \to \infty} \theta = \frac{3.7}{0.0714}(1) = 51.82 rad[/tex]

Convert to rev:

[tex]51.82 rad * \frac{1rev}{2\pi rad} = \boxed{8.25 rev}[/tex]

Answer:

Gravity can pull soil, mud, and rocks down cliffs and hillsides.

Explanation:

Gravity is responsible for erosion by flowing water and glaciers. But gravity also causes erosion directly. This type of erosion and deposition is called mass wasting.

Answer:

Explanation:

Answer:

False, I am pretty sure.

Explanation:

Transverse waves are always characterized by particle motion being perpendicular to wave motion. ... As a sound wave moves from the lips of a speaker to the ear of a listener, particles of air vibrate back and forth in the same direction and the opposite direction of energy transport.

Answer:

Explanation:

As no altitude or mass changed, the potential energy remained constant.

The potential energy will stay the same as long as the book stays on the

table.

Kinetic energy went from zero at rest to a positive value while moving, and then returned to zero when the book was at rest again.

The kinetic energy increases as the book is pushed across the table.

Answer:

from someone watching the bulldozer from the cab of the truck or from elsewhere on the flatbed.

Explanation:

Answer:

Skeletal Muscle cells

Skeletal muscle cells are long, cylindrical, and striated. They are multi-nucleated meaning that they have more than one nucleus. This is because they are formed from the fusion of embryonic myoblasts.

Answer:

skeletal muscle cells can have multiple nuclei

Explanation:

This is because they are formed from the fusion of embryonic myoblasts.

Ice wedging, as described in the passage, is an example of mechanical

weathering.

Mechanical weathering is also known as physical weathering and it

involves the breaking of rock into smaller particles without causing changes

in the chemical properties.Mechanical weathering is usually carried through

physical processes such as freezing and thawing etc.

In this scenario, we were told that water freezes, expands and presses

against the walls of the crack thereby breaking into smaller parts which is a

physical process hence mechanical weathering being present.

Read more about Mechanical weathering on https://brainly.com/question/458304