Answer:
So the total mass is 50 plus 150 grams the heat capacity 4.18 joules per gram per degree C. And the temperature change is 36 minus 25 and so we can calculate Delta H for the reaction that takes place.
Explanation:
2.5 liters of gas is stored at a pressure of 100 atm, if the volume were increased to 4 liters, what would be the new pressure?
a. 250 atm
b. 1000 atm
c. 62.5 atm
d. 160 atm
Answer:
62. 5
Explanation:
Use P1V1=P2V2
100 × 2.5 =250 /4=62.5
life under the sun i need the summaries
Which of the following can be classified as a good conductor of thermal energy?
plastic
wood
rubber
copper
WILL GIVE 50 points I can’t get on to the website so plz help.
Explanation:
can you tell us what do want help with?
Answer:
Ok I will give you answer
Consider the combustion of pentane (C5H12)
a. Write the complete, balanced equation:
b. Determine the limiting reactant if 62.5 grams of pentane combine with 107 L of oxygen gas at STP.
c. If 54.6 L of CO2 gas is produced in the experiment, what is the percent yield?
Explanation:
C5H12 + 8O2 → 5CO2 +6H2O
balanced✓
stable✓
A science teacher places a sealed microwave bag of popcorn on a balance and measures its mass.
She microwaves the popcorn and finds the mass again before opening the bag. The masses are nearly the same.
Which scientific law does this BEST demonstrate?
Law of Conservation of Energy
Law of Thermodynamics
Law of Conservation of Volume
Law of Conservation of Matter
Answer:
D.) The Law of conservation of Matter
Explanation: The popcorn goes into the microwave and since matter cannot be created or destroyed the mass stays the same.
Answer:
aki you there how are you
Explanation:
9.49.8 grams of Kl is dissolved in 1.00 kg of solvent. What is the molality?
Answer:
Molality = 9.498 mol k g − 1
Explanation:
A final way to express the concentration of a solution is by its molality. The molality ( m ) of a solution is the moles of solute divided by the kilograms of solvent. A solution that contains 1.0 mol of NaCl dissolved into 1.0 kg of water is a “one-molal” solution of sodium chloride.
molality = number of moles of solute/ mass of solvent in kg
number of moles of KI = mass of KI / molar mass of KI
number of moles of KI = 9.49.8 g / 1.00 g m o l − 1
number of moles of KI = 9.498 moles
molality = 9.498 moles / 1kg
molality = 9.498 mol k g − 1
what is the physical change of a liquid to a solid by the removal of heat?
Wat two common uses for Cadmium
Answer:
Common (industrial) uses for cadmium today are in batteries, alloys, coatings (electroplating), solar cells, plastic stabilizers, and pigments
How many joules are required to change 40 grams of water to steam at the boiling point?
Answer:
2260 J
Explanation:
For water at its boiling point of 100 ºC, the heat of vaporization is 2260 J g-1. This means that to convert 1 g of water at 100 ºC to 1 g of steam at 100 ºC, 2260 J of heat must be absorbed by the water.
Annie has a soccer ball and a kickball. She kicks each ball with the same force. The soccer ball accelerates at 3 m/s2, and the kickball accelerates at 5 m/s2. Use Newton’s laws to describe why the kickball has a greater acceleration.
Also sorry its actually science
PLS HELP ASAP ON BOTH
Answer:
mesosphere
I hope this helps a little bit.
If 4.04g of h2 gas react with oxygen gas to create 36.36g of water, how many grams of oxygen reacted?
Answer:
gO₂ = 32.32 g
Explanation:
In this case, let's write the general equation:
2H₂ + O₂ -------> 2H₂O
In this case, we can use the 1° law, which is mass conservation. If the product has 36.36 g of water, then in the reactants we should have the same 36.36 g.
According to this, we already have 4.04 of hydrogen, then the remaining to reach the 36.36 g would be:
gO₂ = 36.36 - 4.04
gO₂ = 32.32 gHope this helps
At 35.0°C and 3.00 atm pressure, a gas has a volume of 1.40 L. What pressure does the gas have at 0.00°C and a volume of 0.950 L? Which equation should you use? P subscript 2 equals StartFraction P subscript 1 V subscript 1 T subscript 2 over T subscript 1 V subscript 2 EndFraction. P subscript 2 equals StartFraction T subscript 1 V subscript 2 over P subscript 1 V subscript 1 T subscript 2 EndFraction. P subscript 2 StartFraction equals V subscript 1 V subscript 2 over T subscript 1 T subscript 2 EndFraction P subscript 1.
Answer:
a
3.92
Explanation:
m
Which two types of energy are formed by the transformation shown in the
photo?
O A. Chemical energy - thermal energy
B. Thermal energy - electrical energy
C. Thermal energy - chemical energy
D. Chemical energy - electromagnetic energy
Answer:
D
Explanation:
Hope it helps
#CarryOnLearning
A student combines 20.0 grams of hydrogen and 20.0 grams of oxygen in a reaction. According to the law of conservation of mass, how many grams of water should be produced?
A)20.0grams B)40.0grams C)30.0grams D)10.0grams
Answer:
A)20.0grams
Explanation:
Answer:
10
Explanation:
Will give lots of points if answered correctly. Determine the kb for chloroform when 0.793 moles of solute in 0.758 kg changes the boiling point by 3.80 °C.
Answer: The value of [tex]K_{b}[/tex] for chloroform is [tex]3.62^{o}C/m[/tex] when 0.793 moles of solute in 0.758 kg changes the boiling point by 3.80 °C.
Explanation:
Given: Moles of solute = 0.793 mol
Mass of solvent = 0.758
[tex]\Delta T_{b} = 3.80^{o}C[/tex]
As molality is the number of moles of solute present in kg of solvent. Hence, molality of given solution is calculated as follows.
[tex]Molality = \frac{no. of moles}{mass of solvent (in kg)}\\= \frac{0.793 mol}{0.758 kg}\\= 1.05 m[/tex]
Now, the values of [tex]K_b[/tex] is calculated as follows.
[tex]\Delta T_{b} = i\times K_{b} \times m[/tex]
where,
i = Van't Hoff factor = 1 (for chloroform)
m = molality
[tex]K_{b}[/tex] = molal boiling point elevation constant
Substitute the values into above formula as follows.
[tex]\Delta T_{b} = i\times K_{b} \times m\\3.80^{o}C = 1 \times K_{b} \times 1.05 m\\K_{b} = 3.62^{o}C/m[/tex]
Thus, we can conclude that the value of [tex]K_{b}[/tex] for chloroform is [tex]3.62^{o}C/m[/tex] when 0.793 moles of solute in 0.758 kg changes the boiling point by 3.80 °C.
hello guys,
differentiate between vapourisation and evaporation
Answer:
vapourisation can occur from solid or liquid into a gas but evaporation is straight from a liquid and is often below boiling temperature while vapourisation is often above boiling temperature
Answer:
[tex] \huge\red{\boxed{\mathfrak{Hello}}}[/tex]
[tex]\underline\blue{\textsf{\textbf{Question-}}}[/tex]
Differences between Vaporization & Evaporation:-[tex]{\huge\pink{\fbox{{࿐αɴѕωєя࿐}}}}[/tex]
[tex] \huge\green{ \mid{ \underline{ \overline{ \tt PARAMETERS: }} \mid}}[/tex]
DefinitionTransition of stateSpeed of processEffect areaMovement of molecule[tex] \huge\purple{ \mid{ \underline{ \overline{ \tt VAPORIZATION: }} \mid}}[/tex]
It is defined as the transitional phase of a compound or an element at the boiling temperature.It changes the state of matter from a solid or liquid to a gas.It is generally happening at a fast pace and also it needs less amount of energy.During the vaporization process, all of the water turns into a gas.During vaporization, molecules may come from below the surface of liquid also.[tex] \huge\orange{ \mid{ \underline{ \overline{ \tt EVAPORATION:}} \mid}}[/tex]
It is nothing but a special kind of vaporization and mostly occurring at the temperature below the boiling point.It changes the liquid state of the matter directly into a gas.It is generally a slower process that needs more energy.During the evaporation process, only the top level of water turn into gas.During evaporation, molecules vaporize from the surface of liquid only.➳ ʰᵒᵖᵉ ⁱᵗ ʰᵉˡᵖˢ
[tex] \huge\pink{ \mid{ \underline{ \overline{ \tt ꧁❣ RainbowSalt2222 ࿐ }} \mid}}[/tex]
The molar mass of copper (I) carbonate is
Answer:
[tex]\huge\colorbox{violet}{✏﹏ \: ᴀɴsᴡᴇʀ \: }[/tex]
➳The molar mass of copper (I) carbonate is 187.1 g/mol
[tex] \huge\blue{ \mid{ \underline{ \overline{ \tt ꧁❣ ʀᴀɪɴʙᴏᴡsᴀʟᴛ ²²²² ࿐ }} \mid}}[/tex]
Which is a physical property of a substance?
A. It is flammable.
B. It is odourless.
C. It is corrosive.
D. It explodes when a spark is present.
Explanation:
It explodes when a spark is present.. letter D
Answer:
A. It is flammable.
Explanation:
physical property is a characteristic of matter that is not associated with a change in its chemical composition. Familiar examples of physical properties include density, color, hardness, melting and boiling points, and electrical conductivity.
It takes a season to create a hybrid, and about 15 years to create a_____.
•It takes a season to create a hybrid, and about 15 years to create a Plant variety.
may this helps you
hope it's correct
bye
Why is CaCl, called "calcium chloride" but SCl, is called sulfur
dichloride?
Answer:
because Sulphur is written as S₂
Explanation:
¿Cuál de las siguientes reacciones se encuentra CORRECTAMENTE balanceada?
A.
CH4+2O2→CO2+3H2O
B.
CH4+3O2→CO2+2H2O
C.
2KClO3→2KCl+3O2
D.
3KClO3→3KCl+2O2
Answer:
opción c es la respuesta correcta espero que te ayude
In P plants the gene for the color of the sea has two alleys in the punnets square show me love the dominant alley Y represents yellow and recessive alley Y represents green based on the punnets square what percentage of offspring would be expected to have a green seeds
Answer:
25%.
Explanation:
In the F1 generation, the yellow colour is dominant so 75% of the seeds are yellow colour while on the other hand, 25% seeds are green in colour due to recessive allele. In the F1 generation, the ratio of dominant to recessive allele is 3:1. So on the basis of this 3:1 ratio we can say that there is 75% of yellow colour seeds and 25% of green colour seeds in the population of F1 generation.
how many molecules of CO2 would 700g be?
Answer:
13
Explanation:
if there is a bottle of grape juice with 20% juice and there is 1000mL of total drink, how many mL of water
is in the bottle?
Answer:
760ml of water
Explanation:
Answer: 800mL
Explanation:
20% of 1000mL is 200. 1000mL - 200mL is 800mL
What volume of 1.50 M KBr is fromed ,using 15.6 mL of concentrated KBr with a molarity of 9.65 M?
Answer:
100.4mL
Explanation:
Using the following formula:
C1V1 = C2V2
Where;
C1 = initial concentration (M)
C2 = final concentration (M)
V1 = initial volume (mL)
V2 = final volume (mL)
According to the information in this question,
C1 = 1.50M
V1 = ?
C2 = 9.65 M
V2 = 15.6 mL
Using C1V1 = C2V2
V1 = C2V2/C1
V1 = (9.65 × 15.6) ÷ 1.5
V1 = 150.54 ÷ 1.5
V1 = 100.36 mL
Approximately, V1 = 100.4mL
Help please I’m confused
Answer:1 answer number 1
Explanation:
Why does the chloride ion have a charge of -1
Explanation:
As we know that chloride ion is halogen. So it has seven valence electrons in its valence shell. Hence it gains one electron from others during chemical reaction to be stable. So Chloride ion have a negative charge of -1.
Hope it will help :)❤
A team of scientists claim that they have discovered a new experimental
method for determining percent composition. Which of the following is
necessary for the claim to be considered valid?
A. The method must support the law of conservation of mass.
B. The percent compositions for any two compounds made from the
same elements must be the same.
C. Each atom must contribute the same mass to the compound.
D. All scientists using the new method must get the same results.
Answer:
Option C
Explanation:
The new method must support the law of definite proportions which means that if one mole of compound is distributed percentage wise then the sum of % share of each element must be equal to one mole of compound and this percentage distribution always remains the same in all conditions
Hence, option C is correct