Specific heat capacity
of a solid

Answer:

Explanation:

A wonderful (NOT) mixed unit problem

convert mph to m/s

v = 10 mi/hr(5280 ft/mi)(12 in/ft)(2.54 cm/in) / (100 cm/m) / (3600 s/hr)

v = 4.4704 m/s

KE = ½(0.006)4.4704²

KE = 0.05995342848 J

KE = 0.06 J

Answer:

B. Increase the electric force by rubbing the balloon for a longer period of time.

Explanation:

Answer:

Explanation:

Ignoring friction, the initial kinetic energy will convert to maximum potential energy at its highest point.

PE = KE

mgh = ½mv²

    h = v²/2g

    h = 36.4²/ (2(9.81))

    h = 67.53109...

    h = 67.53 m

Answer:

Explanation:

if you are pulling in the positive direction and Upward is also positive.

F = -0.96i + 0.58(9.8)j

F = -0.96i + 5.7j

F = √(-0.96² + 5.7²) = 5.8 N

You are pulling a sled with constant velocity by using a rope then the surface force the ground exerts on the sled will be 5.8 N.

The pulling force conveyed axially by a string, cable, chain, or another analogous object, or by either end of a rod, truss member, or another such three-dimensional object, is referred to as tension in physics. Another way to think of tension is as the action-reaction pair of forces acting at each end of the previous elements. Perhaps tension is the polar opposite of compression.

A restoring force may cause what is also referred to as tension when atoms or molecules are torn apart from one another at the atomic level and build up potential energy.

If you are moving upward and pushing in a positive way,

F = -0.96 i + 0.58(9.8) j

F = -0.96 i + 5.7 j

F = [tex]\sqrt{(-0.96^2 + 5.7^2)}[/tex]

F= 5.8 N

To get more information about Tension :

https://brainly.com/question/15880959

#SPJ5

Answer:

Water erosion can slowly wash away dirt and rocks, wearing away landforms and sometimes forming rivers that can even carve out stone over time.

Answer:

Explanation:

The word "sheet" implies that the copper is quite thin.

Copper is also a very good conductor of heat.

Therefore, with a very short heat flow distance to cover and a high rate of heat transmission, temperature differences on either side of the sheet are almost instantaneously eliminated by heat flow.

Answer:

I believe The Knowledge that we apply everyday or based on these methods and discoveries may represent us

Explanation:

Answer:

fifth harmonic

Explanation:

Answer:

When the input to an inverter is high (1) the output is low (0); and when the input is low, the output is high.

Answer:

The removal of heat energy slows the speed of particles

Explanation:

When you add heat to a substance, the heat energy gets transferred to kinetic energy, and the molecules began to move a greater distance at a greater speed. When you remove heat, the opposite happens.

Answer:

Electrons

Explanation:

Electrons are negatively charged sub-atomic particles, therefore when a body's negatively charged, it means that there's more electrons than protons.

Answer:

lithosphere

Explanation:

hope this helps you!!

Answer:

3. years

Explanation:

The independent variable is the x axis of graph

Answer:

B

Explanation:

Simply take all forces pointing to the right of the box as positive and all of the forces pointing to the left of the box as negative and add all values.

ΣF = 7 + 18 + (-20) = 5N to the right

The Impulse delivered to the baseball is 89 kgm/s.

To solve the problem above, we use the formula of impulse.

⇒ Formula:

Where:

From the question,

⇒ Given:

⇒ Substitute these values into equation 1

Note: The negative tells that the impulse is in the same direction as the final velocity and therefore can be ignored.

Hence, The Impulse delivered to the baseball is 89 kgm/s.

Learn more about impulse here: https://brainly.com/question/7973509

Based on the information given, it can be noted that the bat was either shorter or longer than what he expected.

From the information given, it was stated that Raghu wants a cricket bat to be made by a carpenter and he tells the carpenter that the length of the bat should be 7 hand spans.

Since he got disappointed when he collected the bat, the reason for this will be because the bat was either shorter or longer than what he requested.

Learn more about length on:

https://brainly.com/question/25292087

[tex]\large\huge\green{\sf{Yes}}[/tex]

Answer:

Explanation:

Objects want to continue doing what they're already doing because they are "lazy." This is called inertia.

None of the given options is correct based on the relationship for the components of the crate's weight.

The given parameter:

The vertical component of the force on the crate is calculated as follows;

[tex]F_y = W \times cos(q)\\\\F_y = F_gcos(q)[/tex]

The horizontal component of the crate is calculated as follows;

[tex]F_x = F_g \times sin(q)\\\\F_x = F_g sin(q)[/tex]

Thus, we can conclude that none of the given options is correct based on the relationship for the components of the crate's weight.

Learn more about forces on inclined weight here:  https://brainly.com/question/11351170

Question

what is the force exerted on a selectively permeable membrane beacuse water has moved from an area of higher concentration to an area of Lower concentration of water?

Answer

OSMOSIS

Explanation

Osmosis: This is the hydrostatic force acting to equalize the concentration of water on both sides of the membrane that is impermeable to substances dissolved in that water. Water will move along its concentration gradient.

HEY!!^^

have a good day^^

thank me later^^^

carryonlearing^^

Answer:

35m/s

Explanation:

Answer:

35m/s

Explanation:

Simply multiply 5 and 7.

Hi there!

1.

Hooke's law states that:

F = -kx

k = Spring constant (N/m)

x = DISPLACEMENT from equilibrium (m)

Essentially, the force of a spring is PROPORTIONAL to its spring constant and its displacement from its equilibrium point.

2.

The force of the spring (T) is not proportional to the spring's length (l), but rather its DISPLACEMENT from its equilibrium length. (Δl)

3.

The equilibrium length is where the force of the spring (T) = 0N. Looking at the graph, the line intersects this value at l = 30cm.

4.

We can begin by looking at the given graph.

When the spring force = 4N, the total length of the spring is 35 cm.

Now, the EQUILIBRIUM length is 30 cm, so the total elongation is:

35 - 30 = 5 cm.

5.1.

If the spring elongates by 10 cm, the total length of the spring is:

30 + 10 = 40 cm

According to the graph, a length of 40 cm corresponds to a force of 8N.

5.2.

We can solve for the weight of the ball using the following:

W (weight) = m (mass) · acceleration due to gravity (10N/kg)

Using a summation of forces:

∑F = T - W

The elongation that we are solving for occurs at the equilibrium point (net force = 0 N), so:

0 = T - W

T = W = 8 N

5.3.

0 = T - Mg

T = Mg

Use the prior value of T and gravity to solve:

8 = 10M

m = 0.8 kg

Answer:

D.

correct me if im wrong

brainlest plsss<333

The relationship between the potential and the electric field allows to find the results for the value of the electric field as a function of the distance is:

Electric potential is defined by the change in potential energy of a test charge between two points, between the value of the test charge.

          dV = - E . ds

          E = [tex]- \frac{dV}{ds} \ \hat s[/tex]  

Where the bold letters indicate vectors, V is the potential difference, E the electric field and s the path.

Let's apply this expression for each section of the given graph:

1) section from x₀ = 0 to x_f = 2 m, the potential is V₀ = 2 V is constant.

  The derivative of a constant is zero.

        E = 0

2) Section between x₀ = 2 and x_f = 4 m, the potential varies linearly from V₀ = 2 v to V_f = -2 V.

We look for the equation of the line.

       V-V₀ = m (x- x₀)

We carry out the derivative.

      E = - m i ^

The slope (m) is:

       [tex]m= \frac{V_f - V_o}{x_f- x_o}[/tex]  

Let's calculate.

       [tex]m= \frac{-2 -2}{4-2} = \ -2 \ V/m[/tex]  

Let's substitute.

       E =  [tex]2 \hat i \ V/m[/tex]  

3) From x₀ = 4 to x_f = 4.5 m, the potential varies from V₀ = -2 to V_f = 0.

We look for the equation of the line and we derive.

      E = - m i ^

Let's  substitute.

      [tex]m = \frac{0-(-2)}{4.5-4} = \ 4 V/m[/tex]  

    E = - 4 [tex]\hat i[/tex] V / m

4) From x₀ = 4.5 m to x_f = 6m.  The potential is constant and the derivative of a constant is zero.

      E = 0

5) From x₀ = 6m to x_f = 8 m, the potential changes linearly from v₀ = 0 to V_f = 1 V

We look for the equation of the line and we derive.

       E = - m i ^

       [tex]m = \frac{1-0}{8-6} = \ 0.5 \ V/m[/tex]  

      E = - 0.5 [tex]\hat i[/tex] V/m

6) From x₀ = 8m to x_f = 9m, the potential changes linearly from V₀ = 1 V to V_f = -1.

We look for the equation of the line and we derive.

       E = - m i ^

       [tex]m = \frac{-1-1}{9-8} = \ -2 \ V/m[/tex]

Let's substitute.

       E = 2 [tex]\hat i[/tex] V/m

7) From x₀ = 9m to x_f = 10 m, the potential changes linearly from V₀ = -1 V to V_f = -2 V

We look for the equation of the line and we derive.

       E = - m i ^

       [tex]m = \frac{-2+1}{10-9} = \ -1 \ V/m[/tex]

Let's substitute.

       E = 1 [tex]\hat i[/tex]  V/m

In the attachment we can see these Electric fields as a function of distance.

In conclusion, the relationship between the potential and the electric field we can find the results for the value of the electric field as a function of the distance is:

Learn more about the electric field here:  brainly.com/question/14306881

Answer:

Explanation:

a) F = ma

a = F/m

a = 9(800) / 1 x 10⁹ = 7.2 x 10⁻⁶ m/s

b) t = v/a

t = 200 / 7.2 x 10⁻⁶

t = 2.8 x 10⁷ s       about 10½ months

c) v² = u² + 2as

s = (v² - u²) / 2a

s = (200² - 0²) / (2( 7.2 x 10⁻⁶))

s = 2.8 x 10⁹ m    nearly 7 times around the earth

And all this assumes NO FRICTION.

Answer:What is the half life of the element Lokium?

The half-live of the element Lokium is 4.

Explanation:

sorry if im wrong, have good day

Answer:

The half-life of the element Lokium is 4

What is half-life?

Whether or not a given isotope is radioactive is a characteristic of that particular isotope. Some isotopes are stable indefinitely, while others are radioactive and decay through a characteristic form of emission. As time passes, less and less of the radioactive isotope will be present, and the level of radioactivity decreases. An interesting and useful aspect of radioactive decay is the half-life. The half-life of a radioactive isotope is the amount of time it takes for one half of the radioactive isotope to decay. The half-life of a specific radioactive isotope is constant; it is unaffected by conditions and is independent of the initial amount of that isotope.

#SPJ2

Answer:

Decant it.

Explanation:

Pour the water/sugar solution off the sand. When the sand wants to start coming out as well, Stop and add fresh water to the beaker, stir to rinse the remaining solution into a less concentrated solution and decant again.

Repeat the dilution process until the mix is essentially sand and water, then drive the remaining water from the sand by drying.

Crazy Wally Ok Ok ok hhahahaha