What patterns do you notice between the three maps? Using the concepts
you've learned in this lesson, construct an explanation for these patterns in your
Science Notebook or in the space below.

Answer:

C. 17

Explanation:

The question above is related to the "Periodic Table of Elements." The Halogen group is located on the right side of the table. It consists of six elements: Fluorine, Chlorine, Bromine, Iodine, Astatine and Tennessine.

The "atomic number" of an element refers to the number of protons that can be found in the element's nucleus. Among the halogens, "Chlorine" is the only one with an atomic number of 17. Halogens do not have an atomic number of 10, 136 and 13.

Answer:

I think it's Nuclear

Answer:

Wood burning would be a chemical change

Explanation:

You cannot undo the change, since the burn will be permanent.

(Hope this helps! If it does not try specifying)

Answer: [tex]KClO_3[/tex] is the limiting reactant in the given reaction.

Explanation:

Limiting reagent is defined as the chemical specie which gets totally consumed in the reaction and the formation of product is dependent on this reagent.

We are given:

Moles of [tex]P_4[/tex] = 30 moles

Moles of [tex]KClO_3[/tex] = 86 moles

The given chemical equation follows:

[tex]10KCIO_3+3P_4\rightarrow 3P_4O_{10}+10KCI[/tex]

By Stoichiometry of the reaction:

If 10 moles of [tex]KClO_3[/tex] reacts with 3 moles of [tex]P_4[/tex]

Then, 86 moles of [tex]KClO_3[/tex] will react with = [tex]\frac{3}{10}\times 86=25.8moles[/tex] of [tex]P_4[/tex]

As, given amount of [tex]P_4[/tex] is more than the required amount. So, it is considered as an excess reagent.

Therefore, [tex]KClO_3[/tex] is considered as a limiting reactant because it limits the formation of product.

Answer:

bond

Explanation:

It is a polar bond because it is when two atoms bond

Answer:

A. Silicon

Explanation:

The ability of an atom to attract electrons is known as electronegativity.

Electronegativity  is the measure of the relative tendency with which the atoms of the element attract valence electrons in a chemical bond.

Answer:

NEWTONS,  

Explanation:

Answer:

kilogram meters2/seconds2

joules

kilojoules

Explanation:

Answer:

2.8g/cm³

Explanation:

Given parameters:

Mass of cube = 42g

Volume of cube  = 15cm³

Unknown:

Density of the cube  = ?

Solution:

Density is defined as the mass per unit volume of a substance. It is mathematically expressed as:

 Density  = [tex]\frac{mass}{volume}[/tex]  

So;

 Density  = [tex]\frac{42}{15}[/tex]   = 2.8g/cm³

Answer:

It the acid easier to handel

Explanation:

The results shows the reactivity of the halogens and how they displace one another from any solution of their compounds.

The oxidizing power of the halogens decreases from top to down on the group. This explains why the more powerful oxidizing halogens displaces the less powerful one from simple salts.

We see that chlorine is able to displace Bromine and iodine

Bromine is only able to displace Iodine

Iodine cannot displace bromine or chlorine

Aluminum is solid at room temperature and will, therefore, have a melting point that is above room temperature.

The room temperature is about 25 degrees Celsius.

Argon and oxygen are gases at room temperature.

Mercury is a liquid at room temperature.

Aluminum, on the other hand, is solid at room temperature. Hence, its melting point is definitely somewhere above room temperature.

More on melting points can be found here: https://brainly.com/question/25777663

Answer:

Hibhibihbhubhibhbuhbuhbhub

Explanation:

Answer:

Examples of measured numbers: The diameter of a coin, such as 10.2 mm. The weight of an object, such as 8.887 grams. The length of a pen, such as 12 cm.

Explanation:

Answer:

It completely depends on what you are measuring, what instrument you are using, and the uncertainty associated with your measurement.

Explanation:

When expressing a measurement, there is always going to be a part that you know, and a part that you guess. They both make up known numbers collectively called significant figures (commonly shortened to "sig figs"). For instance, imagine you are measuring the length of a pencil. Let's say it is a typical ruler with divisions of 0.1 cm (picture for reference). You measure the pencil, and to your eyes it looks like it is about 9 cm and 5 small tick marks (so, 0.5 cm), so we'll call that 9.5 cm. Now, this is a known value, so you are certain that it is a least 9.5 cm. However, it may be true that there is one more decimal place that can be known. The general rule is that you want to add one more uncertain digit to the rightmost side of the number, and how many digits depends on the divisions of the instrument. Our ruler has divisions of 0.1 cm (the small tick marks), and so we will go one more place out, and add another digit. Now, let's say our eyes are pretty good, so let's say it's 9.5 cm, and then add that one uncertain digit, a 0 to the smallest division of 0.1, so, 0.10. The final measurement we record is 9.50 cm. Now, it may seem like we are simply guessing or even being unreasonable in our assessment of how long this pencil is. I can promise you that not knowing the actual measurement of this pencil will not make a spaceship crash because of a specification that was not the "right measurement". For those life-or-death measurements, much more precise measurement machines are used; this is just a pencil. Also, it would be unreasonable to say that it is 9.500000 cm or 9.500001 cm. We do not have that kind of certainty with this ruler, only divisions of 0.1 cm, so we can only estimate out to one more decimal place.

In short, find the smallest division of a ruler or whatever device (like a chemical beaker) you are using, and then add one uncertain digit to the end of that. If it's 0.1 cm, then add one digit to that. (example: 5.6 --> 5.63; 3 because that is what it looks like on the ruler). If it's 1 cm, then add an extra .1, so the measurement is 1.1 cm. And of course, it's not always cm you are using, that was just an example. Best of luck!

Answer:

220g

Explanation:

The reaction equation is given as:

   2C₂H₆   +   7O₂  →  4CO₂   +   6H₂O

Number of moles of ethane gas = 2.5moles

To find the mass of CO₂ produced, we need to know the number of moles of the compound produced;

        2 mole of ethane gas produced 4 moles of CO₂

      2.5 moles of ethane gas will produce [tex]\frac{2.5 x 4}{2}[/tex]   = 5mole of CO₂  

So;

   Mass of CO₂   = number of moles x molar mass

    Molar mass of CO₂   = 12 + 2(16) = 44g/mol

 Mass of CO₂ = 5 x 44  = 220g

Answer:

Theoretically not directly describing, .Atoms vs Ions an ion is an electrically charged particle produced by either removing electrons from a neutral atom to give a positive ion or adding electrons to a neutral atom to give a negative ion. When an ion is formed, the number of protons does not change.

Neutral atoms can be turned into positively charged ions by removing one or more electrons. A neutral sodium atom, for example, contains 11 protons and 11 electrons. By removing an electron from this atom we get a positively charged Na+ ion that has a net charge of +1.

Atoms that gain extra electrons become negatively charged. A neutral chlorine atom, for example, contains 17 protons and 17 electrons. By adding one more electron we get a negatively charged Cl- ion with a net charge of -1.

The gain or loss of electrons by an atom to form negative or positive ions has an enormous impact on the chemical and physical properties of the atom. Sodium metal, for example, which consists of neutral sodium atoms, bursts into flame when it comes in contact with water. Neutral chlorine atoms instantly combine to form Cl2 molecules, which are so reactive that entire communities are evacuated when trains carrying chlorine gas derail. Positively charged Na+ and negatively charged Cl- ions are so unreactive that we can safely take them into our bodies whenever we salt our food.

Explanation:

mark brainlist

Answer:

2

Explanation:

Answer: the health isle next to tooth brushes maybe in a store? Why? Or in a closet? Umm

Explanation:

Answer:

The store.....is this like a trick question...? but yeah A store :))

Explanation:

Answer:

distance velocity displacement, all three

Explanation:

Answer:

B

Explanation:

scientists always look for evidence

Answer:

Yea its B

Explanation: The person above me legit toke the answer out of my mouth

Answer:

Alpha

Explanation:

^4 _2 He = alpha

^0 _-1 b = beta

^0 _0 y = gamma

Answer:

I think it's G

Explanation:

Answer:

eieaowjhfpowwohfawohfawhfae

Explanation:

Answer:  [tex]6.047\times 10^{23}[/tex] atoms in 1.004 mol of arsenic

Explanation:

According to avogadro's law, 1 mole of every substance occupies 22.4 L at STP and contains avogadro's number [tex]6.023\times 10^{23}[/tex] of particles.

To calculate the atoms, we use the equation:

[tex]\text{Number of moles}=\frac{\text{Given atoms}}{\text {avogadro's number}}[/tex]

[tex]1.004=\frac{x}{6.023\times 10^{23}}[/tex]

[tex]x=1.004\times 6.023\times 10^{23}=6.047\times 10^{23}[/tex]

Thus there are [tex]6.047\times 10^{23}[/tex] atoms in 1.004 mol of arsenic

Answer: thay can't make cells

Explanation:

Answer:

Cosmetics

Explanation:

The products of chemical industries that are sued to care for the skin and make people more attractive are cosmetics.

Cosmetics are chemical products used for beauty enhancement.

Answer:

recyclability

Explanation:

recyclability

Explanation:

hope this helps

9.6724 g MgO

Math

Pre-Algebra

Order of Operations: BPEMDAS

Chemistry

Stoichiometry

Step 1: Define

[RxN - Balanced] 2Mg + O₂ → 2MgO

[Given] 5.8332 g Mg

Step 2: Identify Conversions

[RxN] 2 mol Mg = 2 mol MgO

Molar Mass of Mg - 24.31 g/mol

Molar Mass of O - 16.00 g/mol

Molar Mass of MgO - 24.31 + 16.00 = 40.31 g/mol

Step 3: Stoichiometry

Step 4: Check

Follow sig fig rules and round. We are given 5 sig figs.

9.67241 g MgO ≈ 9.6724 g MgO

Answer:

9.6730

Explanation:

i just did the quiz

Answer:

3

Explanation:

Answer:

The Soufriere Hills volcano has formed where magma is actively seeping up from the mantle to the surface. Soufriere Hills volcano is part of an island chain that formed at the boundary where two oceanic plates converge. One plate subducts beneath the plate with the island chain, and the subducting plate melts in the mantle and creates magma that rises and fuels the Soufriere Hills volcano.

Explanation:

Answer:

How many molecules of water are there in 54 g of H2O H 2 O ? Solution. Molar Mass of H2O H 2 O = 2 + 16 = 18 g/moles. So ,number of moles of H2O H 2 O = Mass/Molar Mass = 54/18 =3 moles. Now 1 moles = 6.022×1023 6.022 × 10 23 molecule.