which is not a general characteristic of starburst galaxies?

Explanation:

The resulting displacement of the medium during complete overlap is -1 unit. This is still destructive interference since the two interfering pulses have opposite displacements.

Answer:

179.1 kg

Explanation:

Answer:

Should be 179.1 kg

Explanation:

The force the gun exerts on the pellet at the given acceleration is 80 N.

The given parameters;

The acceleration of the pellet is calculated as follows;

[tex]v^2 = u^2 + 2as\\\\400^2 = 0 + 2(a) (5)\\\\400^2 = 10a\\\\160000 = 10a\\\\16,000 \ m/s^2 = a[/tex]

The force the gun exerts on the pellet at the given acceleration is calculated as;

[tex]F = ma\\\\F = 0.005 \times 16,000\\\\F = 80 \ N[/tex]

Learn more here:https://brainly.com/question/20357188

Answer:

You have to divide your real measurement to the model. For example, if your real measurement is 5m and your model is 20cm, divide 5/20 =1/4 and that means the ratio would be 1:4.

Explanation:

Explanation:

hope this is right!!!!!!!!!!!!!

1. a. Electron 1 -1

b. Proton 2000 +1

c. Neutron 2000 0

2. a. An uncharged nucleon is neutron. It is a chargeless subatomic particle.

b. The particle with the least mass is electron. The mass of an electron is so small that it is considered to be negligible while calculating the atomic mass of an element.

c. The particle with the same mass as a neutron is proton. However if we see the absolute mass of neutron and proton then it is seen that neutron has a greater mass than proton.

d. The particle with the same amount of charge as an electron is proton. Note that the amount of charge is only same. Electron is negatively charged while proton is positively charged.

e. A particle that is negatively charge is electron. The relative charge of electron is -1.

Hope you could understand.

If you have any query, feel free to ask.

There's no way to tell, without knowing the resistance of either X-1 or X-2, or the reading on A3.

Explanation:

acceleration remains constant when velocity does not increase or decrease

Answer

In the parallel circuit, you have to position the switch on only one of the loops.

Answer:

Massm=2.5kg

Massm=2.5kgGravitational potential energy is the work done against force of gravity is stored in the body at a height h .

Massm=2.5kgGravitational potential energy is the work done against force of gravity is stored in the body at a height h .P.E.=U=mgh

Massm=2.5kgGravitational potential energy is the work done against force of gravity is stored in the body at a height h .P.E.=U=mghU=2.5×10×15

Massm=2.5kgGravitational potential energy is the work done against force of gravity is stored in the body at a height h .P.E.=U=mghU=2.5×10×15U=25/10×10×=375j

Answer:

3.09594

Explanation:

hope this helps

Answer:

Δ-727 or -7.27x10²kJ

Explanation:

ΔV=q-w

(q)= -622

(w)= -105

(both negative because it indicate loss of energy)

ΔV= -622+(-105)

ΔV= -727 kJ

The change in internal energy of the system when it released a heat of 622 kJ and does a work of 105 kJ on the surroundings is -727 kJ.

Internal energy is all the energy contained in an object.

To calculate the change in internal energy of the system, we use the formula below.

Formula:

Where:

From the question,

Given:

Substitute these values into equation 1

Hence, the change in internal energy of the system when it released a heat of 622 kJ and does a work of 105 kJ on the surroundings is -727 kJ.

Learn more about internal energy here: https://brainly.com/question/25737117

Answer:

Answer:

1 since it is meatl and sharp

2 since it is sharp and iron

Answer:

Black hole accretion disk emit in the X-rays but neutron star disks are cooler

Hope this Helps

Answer:

question is incomplete

Answer:

15m²

8.6m²

lcm²

6000cm²

0.1km²

40cm²

5210 mm²

500m²

0.0087mm²

500cm²

At the top of the building, the speed of the ball is zero.

The speed increases steadily as the ball falls.

When it hits the street, its speed is 39.6 m/s.

The characteristics of the thermistors allow to design an experiment to analyze the dependence of resistance with temperature;

      1) We set up the circuit

      2) We look for the current of the circuit and we keep it fixed.

      3) We look for the thermistor resistances for each temperature.

      4) Plot Resistance versus Temperature.

A Thermitor is an element whose resistance changes with temperature, for example a platinum resistance.

An experiment that we can carry out to measure is to set up the attached circuit where we have:

Let's start by looking for the current in the circuit.

In thermistors, the resistance for room temperature is given, so if we measure the voltage across the fixed resistor, we can shrink the voltage across the thermistor.

           [tex]V_{source} = V_R + V_{therm} \\V_{therm} = V_{source} - V_R \\ i = \frac{V_{therm} }{R_{therm}}[/tex]

This current remains fixed, since the fixed resistance is greater than the resistance of the thermistor throughout the range.

Second step.

Now we can change the temperature that is measured in the thermometer, for each temperature the voltage in the fixed resistance is measured, the resistance in the thermistor is calculated.

        [tex]R_{therm} = \frac{V_{source} - V_R}{i}[/tex]  

Third step.

We end with a graph of resistance versus temperature of the curve obtained, it is possible to understand the behavior of the resistance of the thermistor with temperature.

In conclusion with the characteristics of thermistors we can design an experiment to analyze the dependence of resistance with temperature:

      1) We set up the circuit

      2) We look for the current of the circuit and we keep it fixed.

      3) We look for the thermistor resistances for each temperature.

      4) Plot Resistance versus Temperature.

Learn more about thermistors here:  brainly.com/question/15690488

Explanation:

kinetic energy of child = 1/2 m v^2

71 j. = 1/2×27kg ×v^2

71×2/27= v^2

142/27 = v^2

5.3. =v^2

v= √5.3

v= 2.3 m/s

Answer:

A rogue wave estimated at 18.3 meters (60 feet) in the Gulf Stream off of Charleston, South Carolina. At the time, surface winds were light at 15 knots.

Explanation:

Rogue, freak, or killer waves have been part of marine folklore for centuries, but have only been accepted as real by scientists over the past few decades.

Rogues, called 'extreme storm waves' by scientists, are those waves which are greater than twice the size of surrounding waves, are very unpredictable, and often come unexpectedly from directions other than prevailing wind and waves.

Most reports of extreme storm waves say they look like "walls of water." They are often steep-sided with unusually deep troughs.

Since these waves are uncommon, measurements and analysis of this phenomenon is extremely rare. Exactly how and when rogue waves form is still under investigation, but there are several known causes:

Constructive interference. Extreme waves often form because swells, while traveling across the ocean, do so at different speeds and directions. As these swells pass through one another, their crests, troughs, and lengths sometimes coincide and reinforce each other. This process can form unusually large, towering waves that quickly disappear. If the swells are travelling in the same direction, these mountainous waves may last for several minutes before subsiding.

Focusing of wave energy. When waves formed by a storm develop in a water current against the normal wave direction, an interaction can take place which results in a shortening of the wave frequency. This can cause the waves to dynamically join together, forming very big 'rogue' waves. The currents where these are sometimes seen are the Gulf Stream and Agulhas current. Extreme waves developed in this fashion tend to be longer lived.

Hope this helps, have a nice day/night! :D

On January 1st, 1995, the first accurate measurement of a rogue wave took place. It was captured by a laser detector on Statoil's Draupner oil drilling rig, which is situated 100 miles off the Norwegian coast.

Although rogue, freak, or killer waves have been mentioned in maritime legend for many years, scientists have only recently acknowledged their existence.

Scientists refer to these waves as "rogues," or "severe storm waves," since they are more than twice as large as the waves around them, very unpredictable, and frequently arrive from directions other than the prevailing wind and waves.

Extreme storm waves are typically described as looking like "walls of water" in reports. Frequently, they have steep sides and exceptionally deep valleys.

Measurements and analyses of this phenomenon are extremely rare because these waves are not common.

Learn more about rogue waves, refer the link:

https://brainly.com/question/14097449

#SPJ2

Answer:

force of gravitational attraction between them also decreases.

Explanation:

force of gravitational attraction between them also decreases.

Answer:

60 N.C

Explanation:

The box will move in the direction of the push and pull with a force of 60 N. C.

If you and your friend are pushing a box at the same constant speed. You pushed 20 feet in 10 minutes, your friend was pushing for 5 minutes. , then the distance must she travel so the two of you can travel at the same speed would be 30 feet.

The total distance covered by any object per unit of time is known as speed. It depends only on the magnitude of the moving object.

As given in the problem If you and your friend are pushing a box at the same constant speed. You pushed 20 feet in 10 minutes, your friend was pushing for 5 minutes.

The distance traveled by box = 20 + 10

                                                 = 30 feets

Thus, the distance must she travel so the two of you can travel at the same speed would be 30 feet.

To learn more about speed here, refer to the link given below ;

brainly.com/question/7359669

#SPJ2

Answer:

For example, an earthquake of magnitude 5.5 releases about 32 times as much energy as an earthquake measuring 4.5. Another way to look at this is that it takes about 900 magnitude 4.5 earthquakes to equal the energy released in a single 6.5 earthquake.

Explanation:

Answer:

When the denominator of both ratios is the same, adding the ratio is simple. You just add the numbers to the left of the colon (this number is called the Ratio Numerator)xplanation:

Answer:

Explanation:

The kinetic energy of an object can be found by using the formula

[tex]k = \frac{1}{2} m {v}^{2} \\ [/tex]

m is the mass in kg

v is the velocity in m/s

To find the velocity we make v the subject of the equation

That's

[tex]v = \sqrt{ \frac{2k}{m} } \\ [/tex]

From the question

k = 76 J

m = 2.3 kg

We have

[tex]v = \sqrt{ \frac{2 \times 76}{2.3} } = \sqrt{ \frac{152}{2.3} } \\ = 8.129388...[/tex]

We have the final answer as

Hope this helps you

Explanation:

ME!!!!!!!!!!!!!!!!!!

Answer:

I Fully Agree with this becoz it is only the key...

Do u agree?

Answer:

(B) The number of protons - only the number of protons in the nucleus determines the element - mass and neutrons can vary for the same element