Which substance will form a solution when mixed in liquid water?

A. He(g)
B. NH3(l)
C. SiO2(s)
D. C5H12(l)

Answer:

1) B

2) D

3) A

4) Ga

5) K

6)Po

7) Atomic size increases down the group

8) B<Al<Ga<In<Tl

9)Se<C<Ga

10) ionization energy is the energy required to remove electrons from the outermost shell of an atom.

Explanation:

In the periodic table, the properties of elements reoccur ''periodically'' throughout the table, hence the name 'periodic table'.

Ionization energy increases across the period hence the noble gas He has the highest ionization energy.

Since ionization energy increases across the period, group 1 elements possess the lowest ionization energy.

Since atomic size increases down the group and decreases across the period, gallium is smaller than indium, potassium is smaller than caesium, polonium is smaller than titanium and iodine is larger than bromine.

This explanation above justifies the order of increasing atomic radius of group 13 elements shown in answer number 8 above.

Since atomic size decreases across the period, the order of increasing atomic size shown in answer number 9 above is correct.

Ionization energy is the energy required to remove electrons from the outermost shell of an atom.

Answer:

Kr- Dispersion Forces

H2O- Hydrogen Bonding

CHCI3- Dipole-Dipole Forces

HF- Hydrogen Bonding

C2H6- Dispersion Forces

HBr- Hydrogen Bonding Forces

Explanation:

Dispersion forces occurs in all substances. They are the dominant intermolecular interaction in all non polar substances such as C2H6 and Kr.

Hydrogen bonding occurs when hydrogen is bonded to a highly electronegative atom such as Cl, Br, O etc. It is the dominant intermolecular interaction in HF, HBr and H2O.

Dipole-Dipole interactions occur when a permanent dipole exists in a molecule such as in CHCI3

Answer:

2.7

Explanation:

Answer:

KOH is the limiting reactant

Explanation:

Hello there!

In this case, according to the given information, it turns out possible for us to identify the required limiting reactant by calculating the moles of water vapor produced by each reactant, CO2 and KOH, as shown below:

[tex]1.4gCO_2*\frac{1molCO_2}{44.01gCO_2}*\frac{1molH_2O}{1molCO_2}=0.0318mol H_2O\\\\2.2gKOH*\frac{1molKOH}{56.11gKOH}*\frac{1molH_2O}{2molKOH}=0.0196mol H_2O[/tex]

In such a way, since 2.2 grams of KOH yield the fewest moles of water vapor, we infer KOH is the limiting reactant.

Regards!

Answer:

as the difference of the energy of the reactants and the energy of the products

In the given potential energy diagram, the energy of product at higher level and energy of reactant at lower level. The for this reaction will be positive. So, the enthalpy of reaction is defined as the difference of the energy of the reactants and the energy of the products.

I hope this helps!

Answer:

berylium

Explanation:

atomic number 4 atomic mass 8 and charge +1

Answer:

1.58×10¯⁷ M.

Explanation:

From the question given above, the following data were obtained:

pH = 6.8

Concentration of hydronium ion [H₃O⁺] =?

The pH of a solution is given by the following equation:

pH = –Log [H₃O⁺]

With the above formula, we can obtain the concentration of hydronium ion [H₃O⁺] as follow:

pH = 6.8

Concentration of hydronium ion [H₃O⁺] =?

pH = –Log [H₃O⁺]

6.8 = –Log [H₃O⁺]

Multiply both side by by –1

–6.8 = Log [H₃O⁺]

Take the anti log of –6.8

[H₃O⁺] = antilog (–6.8)

[H₃O⁺] = 1.58×10¯⁷ M

Therefore, the concentration of hydronium ion [H₃O⁺] in the solution is 1.58×10¯⁷ M.

Answer:

12

Explanation:

nNaCl= 4x3=12

Answer:

The given molecules are:

CH2Br2

CH3NH2

LiF

C3H8

CF4.

Which compound consists of the hydrogen bond as the strongest intermolecular force.

Explanation:

The hydrogen bond is the electrostatic force of attraction that exists between the covalently bonded H-atom of one molecule and a high electronegative atom (N, O, F) of another molecule.

For example, H-bonding in water is represented below:

Among the given molecules,

CH2Br2 does not have H-bond because there is no either N or O or F atom in it.

In LiF also there is no H-atom and no hydrogen bond.

C3H8 also does not have H-bond in it.

CF4 also does not have H-atom or hydrogen bond in it.

The answer is CH3NH2(methylamine).

It has an intermolecular hydrogen bond in it as shown in the attachment.

The dashed line represents the H-bond.

my answer

Explanation:

Answer. Filtration is the method of separating a solid from a liquid. A sieve sets a threshold calibration through which all undersized materials pass through. Filtration differs from sieving, where separation occurs at a single perforated layer (a sieve).

Answer:

Filtration

Explanation:

Metal carbonate is insoluble, it is possible to filter off the unreacted substances leaving the desired salt solution

Answer:

a. NADH and FADH₂ donate electrons to the electron transport chain

b. Molecular oxygen, O₂, is the final electron acceptor

c. The final products of the electron transport chain and oxidative phosphorylation are as follows: NAD+, FAD+, H₂O, and ATP

Explanation:

The citric cycle oxidize acetylCoA molecules to carbon dioxide and in the process produce the reduced coenzyme NADH and FADH₂. These reduced coenzymes then are able to donate their electrons to various complexes in the electron transport chain. The flow of these electrons through the electron transport chain is coupled to proton pumping out of the mitochondrial matrix into the intermembrane space. Ultimately, the energy of the proton motive force is used to drive synthesis of ATP from ADP and inorganic phospahte and the electrons are accepted by molecular oxygen to produce water. This process is known as oxidative phosphorylation.

Therefore, the answers to the given questions a, b and c are as follows:

a. NADH and FADH₂ donate electrons to the electron transport chain

b. Molecular oxygen, O₂, is the final electron acceptor

c. The final products of the electron transport chain and oxidative phosphorylation are as follows: NAD+, FAD+, H₂O, and ATP

Answer:

Answer:

D. the minerals they contain

Hope this answer is right!!

Answer:

the answer is 0.078

Explanation:

edge 2021

Answer:

The next answers are

4.96

Wax

oxygen

Calculated based on the chemical equation:

✔ theoretical yield

Measured directly:  

✔ experimental yield

Determined experimentally:  

✔ experimental yield

Determined using stoichiometry:  

✔ theoretical yield

BOTH

ALL OF THE ABOVE

using accurate measurements

using pure chemicals

performing the reaction under the most ideal conditions

Explanation:

Explanation:

las levaduras son pequeños organismos unicelulares que se alimentan de azúcares simples y los descomponen en dióxido de carbono, alcohol (etanol, específicamente), moléculas de sabor y energía. El proceso se conoce como fermentación.

Answer:

See explanation and image attached

Explanation:

The image attached shows the entire scheme of reactions mentioned in the question.

The first reaction is an addition reaction which yields a tertiary alkyl halide as shown in accordance with Markovnikov rule.

The second reaction is a dehydrohalogenation in which the base abstracts a proton from the alkyl halide followed by loss of a bromide ion to yield the corresponding alkene.

This alkene is an isomer of the starting material.

Answer:

10/3

Explanation:

Hope this helps

Answer:

The compound formula for the ammonia is

N

H

3

. It is a colorless gas. It is the result of the chemical reaction between nitrogen and hydrogen gas. The chemical reaction between the gases is shown below:

N

2

+

3

H

2

→

2

N

H

3

Answer:

6 molecules

Explanation:

Only three elements are present in the products of photosynthesis: oxygen, carbon, and hydrogen. These same elements are present in the reactants of photosynthesis. Notice that it takes six molecules of water and six molecules of carbon dioxide to make one molecule of glucose

Answer:

6 molecules of carbone dioxide.

Answer:

false

Explanation:

consumers eat producers

Answer:

False. If they are talking about food today.

Answer:

B

Explanation:

its answer aExplanation:

Answer:

7.16 × 10⁻³ M

Explanation:

Let's consider the reduction reaction of copper during the electroplating.

Cu²⁺(aq) + 2 e⁻ ⇒ Cu(s)

We can calculate the moles of Cu²⁺ present in the solution using the following relations.

The moles of Cu²⁺ reduced are:

[tex]2.30 min \times \frac{60s}{1min} \times \frac{3.00C}{s} \times \frac{1mole^{-} }{96486C} \times \frac{1molCu^{2+} }{2mole^{-} } = 2.15 \times 10^{-3} molCu^{2+}[/tex]

[tex]2.15 \times 10^{-3} moles[/tex] of Cu²⁺ are in 0.300 L of solution.

[Cu²⁺] = 2.15 × 10⁻³ mol/0.300 L = 7.16 × 10⁻³ M

Answer:

0.01684 s⁻¹

Explanation:

In a first-order reaction, the rate is proportional to the concentration of only one reactant (raised by 1). In this case, the reactant is H₂O₂. Thus, the rate law is the following:

rate = k [H₂O₂]

We have the following data for the initial rate:

rate = 0.00842 mol/(L·s)

[H₂O₂] = 0.500 mol/L

So, we introduce the data in the expression for the rate law to calculate k:

k = rate/[H₂O₂] = (0.00842 mol/L·s)/0.500 mol/L = 0.01684 s⁻¹

Answer:

Option D

Explanation:

A double displacement reaction is a type of reaction in which two reactants exchange ions to form two new compounds.

CaBr2 + 2NaOH → Ca(OH)2 + 2NaBr

Calcium Bromide + Sodium Hydroxide = Portlandite + Sodium Bromide

Answer:

The answer is in the explanation.

Explanation:

A buffer is defined as the aqueous mixture of a weak acid and its conjugate base or vice versa. Buffers are able to avoid the pH change of a solution when strong acid or bases are added (As NaOH).

Based on the experiment, it is possible that the solution Z was a buffer and Y another kind of solution. For this reson, pH of the solution Y changes much more than the pH of solution Z changes despite the amount of NaOH added is the same in both solutions.

Explanation:

hope the picture make sense :)

Answer:

Hey mate......

Explanation:

This is ur answer......

molecules in liquids are weaker than solids but stronger than gases......

Hope it helps!

Brainliest pls!

Follow me! :)