Engineering

discuss the difference between a dual split and a diagonal split master cylinder.
2 Answers
A cantilever beam of span 6 m is subjected to transverse shear force of 5 kN at free end. Beam is having rectangular cross-section of dimension 40 mm x 50 mm. Determine the magnitude of shear stress (kPa) on an element a lying at a distance of 20 mm from neutral axis. (6 pts)
1 Answer
How does automobile exhaust gases contribute to air pollution?
1 Answer
Wyatt is handling the urban design of an area. He ensures that there are speed bumps and traffic lights on roads. Which activity in urban design is Wyatt ensuring?A. suburban sprawlB. excavationC. traffic calmingD. landscapeE. expansion
1 Answer
What event occurred closest in the time to the sinking of the Titanic?O The Civil WarO World War 1O World War 2The Vietnam War
1 Answer
technician a says when diagnosing brake system troubles, the symptoms you should be use is improper braking action. technician b says when diagnosing brake system troubles, the symptoms you should be use is improper taillight operation. who is right? group of answer choices (a) a only. (b) b only. (c) both a and b. (d) neither a nor b.
1 Answer
The home inspector should measure the _____ depth of insulation observed at the unfinished attic floor.
1 Answer
List two ways you can make an informal survey
2 Answers
While preparing to drive a HMMWV forward under normal conditions, in what position should you place the transmission and transfer case shift levers
1 Answer
The condensed Q formula may be used for operations in which the friction loss can be determined for:
1 Answer
What does it mean when your car says engine power reduced?.
2 Answers
Technician A says when the resistances in a parallel circuit are not equal, then the current divides in accordance with the value of each resistance, but the total current flow is still the sum of the currents flowing in each branch. Technician B says all components in a parallel circuit are connected directly to the same voltage supply. Who is correct?
1 Answer
When is creep important to metals
1 Answer
Who is the first engineer of world ? and why?
1 Answer
12. Technician A says that some seam sealers may be applied over bare steel.Technician B says that some undercoating may be applied over bare steel.Who is right?1A onlyOB onlyBoth A and BNeither A nor B
1 Answer
All of the following statements with respect to manual transmission are true EXCEPT: Group of answer choices gears can be applied only when the clutch is depressed. when in gear, releasing the clutch connects the engine to the transmission. releasing the clutch pedal closes the contacts of the clutch safety switch. the transmission provides the best pulling power in the lowest gear.
1 Answer
A technician needs to check the heating operation of a heat pump that has no gauge access ports. The technician should start by:
1 Answer
In a series circuit do each bulb get the full electrical pressure.
1 Answer
Technician A says that if drum brake shoes become saturated with gear oil or grease, they should be replaced. Technician B says that drum brake shoes can be cleaned and reused if the lining becomes contaminated with gear oil or grease. Who is correct
1 Answer
a. 1.2K =what is the ohms
1 Answer
All aspects of the Kirby-Bauer test are standardized to assure reliability. What might be the consequence of pouring the plates 2mm deep instead of 4mm deep
1 Answer
If particleboard is used as wall sheathing, the grade mark with type _____ or _____ should be stamped on it.
1 Answer
When a technician is ohming out a load in a circuit, what reading should the technician get if the load is good
1 Answer
A discharging lead-acid battery is best described as.
1 Answer