1+1 =?
2+2=?
3+3=?

1+1 =?
2+2=?
3+3=?

Hi there!

If we sum the forces acting on the bucket:

∑F = T (upward) - Mg (downward)

Thus:

ma = T - mg

We can rearrange for T:

ma + mg = T

Plug in the given values:

4.6(3 + 9.8) = T = 58.88 N

The force required to start the block in motion is equal to 39.2 Newton.

Given the following data:

To determine the force required to start the block in motion:

Note: The force that is required to start the block in motion must be greater than or equal to the force of static friction.

Mathematically, the force of static friction is given by the formula;

[tex]Fs = uFn = umg[/tex]

Where;

Substituting the given parameters into the formula, we have;

[tex]F_s = 0.4 \times 10 \times 9.8\\\\F_s = 4 \times 9.8\\\\F_s = 39.2\;Newton[/tex]

Read more on force of static friction here: https://brainly.com/question/25686958

Hi there!

We can first find the angular displacement of the first 20 seconds by finding the angular acceleration.

Begin by converting 120 rev/min to rev/sec:

120 rev/min × 1 min/60 sec = 2 rev/sec

ω = αt

2 = 20α

α = 0.1 rev/sec²

θ = ωit + 1/2αt²

The fan starts from rest, so:

θ = 1/2αt²

θ = 1/2(0.1)(20²) = 20 revolutions

Now, for the next 40 seconds, we can find the fan's deceleration:

ωf = ωi + αt

0 = 2 + αt

-2 = 40α

α = -0.05 rad/sec²

Use the above equation:

θ = ωit + 1/2αt²

θ = 2(40) + 1/2(-0.05)(40²) = 80 - 40 = 40 rev

θ = 4800 - 2400 = 2400 revolutions

Add the two:

θtotal = 20 + 40 = 60 revolutions

Answer:

combine them all

6 m

Explanation:

Answer:

I am not quite sure....

Explanation:

Explanation:

basically i, say the answer is w

Answer:

10cm

Explanation:

25/20=x/8

cross multiply;

200=20x

x=10

Answer:

57.97m/s

12.1s

Explanation:

Use one of the key equations of accelerated motion and sub in the values

vf^2=vi^2+2aΔd

vf^2=(20)^2+(2*9.8)(150)

vf^2 = 3340

vf = 57.79m/s (square rooted both sides)

now use another equation

Δd = (vi+vf/2)Δt

and rearrange for Δt

Δt = (2Δd-vf)/vi

sub in values

Δt = (2*150-57.79)/20

Δt = 12.1s

mark me as brainliest if this helped!

Answer:

Rocks from early Earth that contained copper are red in color

Explanation:

"Copper, a red mineral, reacts with oxygen to form a green-colored compound. In early years, rocks containing copper were red. This fact shows that there was no oxygen in the early atmosphere to oxidize red copper into the green-colored compound."

Answer:

.............................

Answer:   By squeezing the balloon, you reduce the space the gas particles can occupy. As the particles are pushed a bit closer together, they collide with more, so the pressure from the moving gas particles increases. If the volume increases, its pressure decreases.

Force of air and gravitational force are acting on the ball when launched from the slingshot.

When a ball is launched from a slingshot, during its travel force of air as well as gravitational force are acting on the ball because there is air which moves opposite to the motion of a ball whereas the force of gravity attracts the ball downward.

The force of air slows down the motion of the ball while on the other hand, the force of gravity brings the ball to the ground due to attraction. If these two forces are not present then the ball continues its motion forever so we can conclude that force of air and force of gravity are acting on the ball when launched from the slingshot.

Learn more: https://brainly.com/question/25533186

Answer:Thus for n=1 number of electrons is 2 and for n=2 the number of electrons is 8. Hence the electronic configuration of the element X is 2,8,6 and its atomic number is 16. In the Modern Periodic Table, the element Sulphur has atomic number 16. So, the solution is that the element X is Sulphur and it is non metallic.

Answer:

Explanation:

Answer: Thus for n=1 number of electrons is 2 and for n=2 the number of electrons is 8. Hence the electronic configuration of the element X is 2,8,6 and its atomic number is 16. In the Modern Periodic Table, the element Sulphur has atomic number 16. So, the solution is that the element X is Sulphur and it is non metallic.

Answer:

Earth because of greater gravity

Answer:

6.5

Explanation:

Because 1.5+5=6.5

Just divide the both, you will get the answer!

does it sound rude?

im sorry for that!

Answer:

10

Explanation:

Answer:

72n

Explanation:

(a) Since the charge at any point inside sphere is zero.

by Gauss law,E=0.

(b) Just outside, E=q/4πϵ  o ​  r  2   so, E=10  5  NC  −1  

(c) q=1.6×10  −7 C r=18 cm E=q/4πϵ  o  r  2 E=4.4×10  4  NC  −1

Answer:

Falling objects form an interesting class of motion problems. For example, we can estimate the depth of a vertical mine shaft by dropping a rock into it and listening for the rock to hit the bottom. By applying the kinematics developed so far to falling objects, we can examine some interesting situations and learn much about gravity in the process.

The most remarkable and unexpected fact about falling objects is that, if air resistance and friction are negligible, then in a given location all objects fall toward the center of Earth with the same constant acceleration, independent of their mass. This experimentally determined fact is unexpected because we are so accustomed to the effects of air resistance and friction that we expect light objects to fall slower than heavy ones.

In the real world, air resistance can cause a lighter object to fall slower than a heavier object of the same size. A tennis ball will reach the ground after a hard baseball is dropped at the same time. (It might be difficult to observe the difference if the height is not large.) Air resistance opposes the motion of an object through the air, while friction between objects, such as between clothes and a laundry chute or between a stone and a pool into which it is dropped, also opposes motion between them. For the ideal situations of these first few chapters, an object falling without air resistance or friction is defined to be in free-fall.

Hope this helps, have a nice day/night! :D

Answer:

D. The acceleration is downward at all points in the motion

Explanation:

:D

Answer:

a)object is in uniform motion

Explanation:

velocity is constant.and a=0

body is in uniform motion.

BRAINLIST PLS

Answer:

Russia

Explanation:

my answer was deleted for no reason. apparently i was violating community guidelines when i wasnt. anyways, the answer is russia...

In a radio frequency identification (RFID) system, the unique data identifying an item are typically found in: tags.

What is an RFID system?

RFID is an acronym for radio frequency identification.

A RFID system can be defined as an automatic, wireless, identification technology (device) that is typically designed to allow end users store and retrieve information, especially through the use of an electromagnetic field.

The operational benefits of an RFID system:

Generally, a radio frequency identification (RFID) system is used for the following:

1. To identify an item or individual.

2. To trace and tracking an item or individual.

3. To track an item or individual.

The components of an RFID system:

An RFID system is a wireless, identification technology (device) that comprises two (2) main components and these are:

Tags refer to small objects containing an antenna and a chip (smart barcodes) that are used to automatically identify an item or individual they are embedded in or attached to.

In conclusion, the unique data that are used in identifying an item are typically found in tags.

Read more on RFID tags here: https://brainly.com/question/24167692

Answer:

Explanation:

Ruler. A steel ruler aids the measurement and layout of straight lines. The ruler, also called "straightedge" or "straight-edged ruler," is a long, thin strip of wood, metal or plastic marked with increments of measurement.

Measuring Tape. The modern measuring tape's roughly palm-sized casing contains a coiled strip of metal marked with increments of measurement. The metal strip, called "tape," attaches to a spring which automatically retracts the tape into the casing following use.

Walking Tape Measure. The walking tape measure, also called "surveyor's measure," records the distance traveled by a wheel. An operator pushes the measure's wheel, similar to a bicycle wheel, by a handle as an attached ticker box displays feet or meters in the same format as a car's odometer.

Laser Measure. The laser measure offers point and shoot distance measurement. In its most basic form, a laser measure is a hand-held electronic device with a digital display.

Answer: Pressure is proportional to force and inversely proportional to area.

Explanation:

[tex]\text{Given that },\\\text{Mass, m = 6 kg}\\\\\text{Acceleration, a = 6 } \text{m} \text{s}^{-2}\\\\\text{Time, t=9 sec}\\\\\text{Displacement, }s=ut + \dfrac 12 at^2 = \dfrac 12 at^2 = \dfrac 12 \times 6 \times 9^2 = 243 ~m}\\\\\ \text{Work,} ~W = Fs = mas = 6 \times 6 \times 243 = 8748 ~ J}[/tex]

Hi there!

We know that:

[tex]W = \Delta KE = \frac{1}{2}m(\Delta v)^2[/tex]

We can begin by solving for the final velocity using the equation:

[tex]v_f = v_i + at[/tex]

The box starts from rest, so:

[tex]v_f = at\\\\v_f = 6(9) = 54 m/s[/tex]

Now, we can find the kinetic energy:

[tex]KE = \frac{1}{2}mv^2\\\\KE = \frac{1}{2}(6)(54^2) = 8748 J[/tex]

Thus:

[tex]W = \Delta KE\\\boxed{W = 8748 J}[/tex]

Answer:

66,000J

Explanation:

Mechanical energy = Gravitational energy + Kinetic Energy

ME = 6,000 + 60,000 = 66000 J

Answer: Levers

Explanation: Levers lifte

the machines arm