Answer:
could you elaborate a bit more
What strategies can you use to reduce your electricity bill? How much money could you save? Write your answers on the back of this sheet or on a separate sheet of paper. If possible, discuss your ideas with your classmates and teacher.
Answer:
stop leaving the stove on, turnof ligts, unplug appliances like air fryers when not in use.
Explanation:
hope this helps, these are just some ideas!
The strategies that can be used to reduce your electricity bill are to turn off lights, disconnect appliances like air fryers when not in use, and quit leaving the stove on.
Why it is important to save electricity?A hundred years or so ago, electricity began to be widely distributed. Humanity made progress through this method. Today, electricity is used in every industry sector and in all other domains.
You may save money, improve your energy security, and lessen the pollution caused by non-renewable energy sources by reducing energy use in your house.
Therefore, the strategies to save electricity are:
Make use of energy-efficient lighting.Energy-efficient lighting should be used instead of standard bulbs.Turn off the lights in areas where no one is present.To learn more about saving electricity, visit here:
https://brainly.com/question/29767170
#SPJ2
Need help with these 3 questions pls help
Answer:
I think 5 is passion and 6 is true I think and 7 is time management I'm pretty sure
Which comment is someone who has a conventional personality type likely to make?
“Don’t tell me; show me.”
“Status is important to me.”
“How can I help?”
“Just do it.”
“I express myself, therefore I am.”
Answer:
“How can I help?”
Though a second could be “Don’t tell me; show me.”, but that is very authoritative , while conventional personalities types don't typically like to be in an authoritative position.
Explanation:
Answer:
just do it
Explanation:
I mean, its Nike's trademark.
Drag the tiles to the correct boxes to complete the pairs. Not all tiles will be used.
Match each temperature scale to its respective temperature scale after conversion.
90ºC
176ºF
203 K
-58ºF
283 K
213 K
-71ºF
-50ºC
arrowRight
80ºC
arrowRight
363 K
arrowRight
50ºF
arrowRight
Answer:
Check image, right on PLATO
Explanation:
Every two years or at recommendation by manufacturer.
Answer:
Manufacturer’s Recommendations means the instructions, procedures, and recommendations which are issued by the manufacturer of any equipment used at the Facility relating to the operation, maintenance, or repair of such equipment, and any revisions or updates thereto from time to time issued by the manufacturer.
Manufacturer’s Recommendations means the instructions, procedures and recommendations which are issued by any manufacturer of the Equipment relating to the operation, maintenance and repair of the Equipment and any revisions to such instructions, procedures and recommendations agreed to by any manufacturer of the Equipment and which are valid at the time such operation, repair and maintenance is being carried out.
Manufacturer’s Recommendations means the written instructions, procedures and recommendations which are issued by the original equipment manufacturer of any plant or equipment used at the Utility Plant relating to the operation, maintenance and repair of such plant or equipment and any revisions thereto issued by the manufacturer, which are valid and applicable at the time such operation, maintenance or repair is undertaken. Notwithstanding the above, Manufacturer’s Recommendations shall not include any instructions, procedures or recommendations of a manufacturer of any plant or equipment that the Owner and the Operator have agreed in writing to exclude from this definition or have agreed in writing should not be followed.
Explanation:
CAN SOMEONE PLEASE HELP ME-
Answer:I- I’m idiot now
Explanation:
what are specialized components in manufacturing?
Answer:
Specialized Bicycle Components, Inc., colloquially known as and stylized as SPECIALIZED, is an American company that designs, manufactures and markets bicycles, bicycle components and related products under the brand name "Specialized", as well as the premium and professional oriented "S-works".
The Morgan Hill, California-based company was founded in 1974 by Mike Sinyard.
The company was founded in 1974 by Mike Sinyard, a cycling enthusiast who sold his Volkswagen Bus for $1,500 to fund a cycle tour of Europe, where he bought handlebars and stems made by Cinelli to take back to the US. Sinyard started out importing Italian bike components that were difficult to find in the United States, but the company began to produce its own bike parts by 1976, starting with the Specialized Touring Tire. In 1981, the company introduced its first two bikes, the Sequoia, a sport-touring design and the Allez, a road bike. Specialized also introduced the first major production mountain bike in the world, the Stumpjumper, in 1981. Like the Sequoia and Allez, the Stumpjumper was designed by Tim Neenan and based on an early Tom Ritchey design. Specialized continues to produce bikes under the Stumpjumper name, including both hardtail and full-suspension models. An original Stumpjumper is displayed in the Smithsonian Institution in Washington, D.C. In 1989, Specialized introduced the Epic, the world's second mass-production carbon fibre mountain bike.
Explanation:
What is the line called that has the red arrow pointing to it in the attached picture?
Answer:
csvadbvns egv,ekrhvybge e yrbge ngeeeeerhjyk4 r5y erhyniner mbrltjhnprihmb fghurijmb fm nbjrkfb
Explanation:
So long ago they used a sundial to tell if. it starts with a "C" if you want me to spell it.
Answer:
what is it
Explanation:
Answer:
Clock
Explanation:
To tell clock, long ago people uses sundial.
A _______ contact allows current to flow when the switch's operator is not activated.?
Answer:
Normally closed (NC)
Explanation:
Ohm's law states that at constant temperature, the current flowing in an electrical circuit is directly proportional to the voltage applied across the two points and inversely proportional to the resistance in the electrical circuit.
Mathematically, Ohm's law is given by the formula;
[tex] V = IR[/tex]
Where;
V represents voltage measured in voltage.
I represents current measured in amperes.
R represents resistance measured in ohms.
A switch can be defined as an electronic component or device that is typically used to prevent or allow the flow of electric current (electrons) from one point to another in an electrical circuit.
There are two logical forms used for designing a switch and these includes;
I. Normally opened (NO).
II. Normally closed (NC).
A Normally closed (NC) contact allows current to flow when the switch's operator is not activated.
Basically, a Normally closed (NC) contact would always remained closed unless a certain (specific) condition is met. Thus, when the contacts are moved, the circuit becomes open and thus, prevents the flow of electric current in the circuit.
PLEASE HELP, I WILL MARK AS BRAINLIEST, URGENT!!!
1. Enzymes used by fireflies are used to improve:
a
Food safety
b
Adhesives
c
Airplanes
d
Coats
2. Spiderweb have how many different kinds of silk?
a
6/7
b
10
c
1/2
d
8/9
1.Enzymes used by fireflies are used to improve Food Safety .
2.They have seven different kinds of silk.
Option A
Mark it BRAINLISTForce = 33 newtons
race
orce = 27 newtons
What is the sum of the net torce on the box in the day am abover
6 news, sp
06 nentons, dow
50 newtons, COW
5 news, Up
Answer:
answer
Explanation:
Solve the Truss. Your end result should be
a diagram with all member and reaction
forces labeled with the amount of force and
either the direction indicated with an arrow
or whether it is under Tension(positive) or
compression(negative).
Answer:
Please find attached the diagram end result of the truss with the member reaction forces labelled with the amount of forces as required, created with Microsoft Visio
Explanation:
To answer the question, we note that the sum of the forces in the Truss is zero
Therefore, we have, ∑Fₓ = [tex]\Sigma F_y[/tex] = 0 N
The forces on the members CD and AD are therefore as follows;
Horizontal forces;
[tex]F_{CD}[/tex] × cos(45°) - [tex]F_{AD}[/tex] × cos(30.964°) = 100.0 N...(1)
[tex]F_{CD}[/tex] × sin(45°) + [tex]F_{AD}[/tex] × sin(30.964°) = 750.0 N...(2)
Solving the above system of equations using a graphing calculator gives;
[tex]F_{CD}[/tex] ≈ 715.94 N (Tension)
[tex]F_{AD}[/tex] ≈ 473.76 N (Compression)
[tex]F_{Cy}[/tex] + [tex]F_{Ay}[/tex] = 750.0 N
[tex]F_{Ax}[/tex] = 100.0 N
From ∑M[tex]_c[/tex] = 0, we have;
[tex]F_{Ay}[/tex] × 8 = 750 × 3 + 100 × 3
[tex]F_{Ay}[/tex] = 2550/8 = 318.75 N
∴ [tex]F_{Cy}[/tex] = 750.0 N - [tex]F_{Ay}[/tex] = 750.0 N - 318.75 N = 431.25 N
I hit someone with my car because he tried to hijack it.
Will I be arrested?
100 points, and brainliest.
(hope he didnt fall off the bridge.)
Answer:
no you wont
Explanation:
Select the correct answer.
Which of these risks might prevent an agricultural biotechnology company from using genetic material from peanuts to modify other plant varieties?
A.
the risk of transferring allergens to the modified plants
B.
the risk of destroying organic varieties of the modified plants
C.
the risk of harming rare birds that feed on the modified plants
D.
the risk of the genes entering animals that feed on the modified plants
E.
the risk of the genes causing cancer in people who eat the plants
Answer:
the best answer is A
Explanation:
Need help with these 3 questions pls help me.
Answer:
First one is probably B
Second one is False
Third one is True
Explanation:
Every workplace or school is different so I'm not really sure.
Answer:
10.B 11.false and 12.true
Explanation:
People with artistic orientation at times resist rules and structure.
True
False
Which of the following tasks are performed by the marketing department:
Select one:
a. Find out what customers want in new products.
b. Promotes products to potential customers.
c. Design products.
d. Provide after-sales service.
The two basic categories of electrical switches are manual and ??
Explanation:
Single Pole Single Throw Switch
Single Pole Double Throw Switch
Double Pole Single Throw Switch
Double Pole Double Throw Switch
Push Button Switch.
Toggle Switch.
Limit Switch.
Float Switches.
In the simplest case, a switch has two conductive pieces, often metal, called contacts, connected to an external circuit, that touch to complete (make) the circuit, and separate to open (break) the circuit
Two basic categories of electrical switches are manual and automatic.
What are electrical switches?
A switch that opens and closes an electric circuit is typically electromechanical in nature. This, correspondingly, stops and starts the flow of electric current.
A mechanical handle, lever, or rocking mechanism is used to manually activate (or push up or down) a toggle switch. These are frequently employed as switches for lighting.
An electrically controlled switch is a relay. It is made up of a set of working contact terminals and a set of input terminals for one or more control signals. Any number of connections in different contact configurations, such as making contacts, breaking contacts, or combinations of both, may be included on the switch.
Therefore, electrical switches can be divided into two fundamental categories: manual and automatic.
To learn more about electrical switches, refer to the link:
https://brainly.com/question/29045327
#SPJ2
Beginning in the 1960s, various advocates of the design-build model began to agitate against the design-bid-build approach and for a change,
O False
O True