Part C
In the Options window of the simulation, select Pie to show the pie chart. In the window labeled Start with how many, use the up arrows to add 40 particles of A and 40 particles of BC. Then press the Begin experiment button. Wait a few seconds for the reaction to come to equilibrium, and then click pause near the bottom of the screen.

Study the graph on the left. The green line shows total average energy. The blue line shows the amount of potential energy possessed by the reactants and the products. Recall that substances most readily take the form in which they have the least potential energy. The amount of potential energy can be adjusted, affecting the outcome of the reaction. Recall that in the initial experiment for synthesizing ammonia, only about 20% of the reactants were converted to the products.

Click the Play arrow to resume the simulation. Then adjust the potential energy curve so the proportion of reactants to products is roughly the same as the proportion in the initial experiment. Adjust the center slider up or down so there’s a bump in the middle of the energy curve. The bump represents the energy the particles must have to react. Take a screenshot of the energy curve, and use the Insert Image button to paste it in the answer space.

Answer:

joule

Explanation:

Explanation:

Answer and Explanation: Photon is the basic unit of light. The excited state refers to the state when any specified electron gained some energy from surrounding. In the ground state, the electron carries no energy and this refers to its lowest energy level.

Explanation:

The First Law of Thermodynamics states that energy cannot be created or destroyed in an isolated system. In other words, energy can be converted from one form into another, but it cannot be created nor destroyed.

Conduction is the transfer of energy from one molecule to another by direct contact. This transfer occurs when molecules hit against each other, which can take place in solids, liquids, and gases.

When you put your cold hands under your legs to warm your hands up, the heat energy from your legs is being transferred to your hands through conduction. However, since energy cannot be created, there is no extra heat energy that can instantaneously replace the heat created by your legs.

Every metabolic process involves energy transfer. Since as the total energy is conserved and thus no loss or gain of energy will be there in a system and to maintain this equilibrium energy transfer from lower energy spot to higher energy spot.

Thermal energy is the energy in the form of heat and which can transfer from one part to the other as any other energy form.

As energy is conserved in a system there will be no net gain or loss of energy overall. Thus energy lost from one part travels to the other parts. Any energy forms transfer from a low intense area to high intense area.

When our hand cools down we may warm them up by rubbing on legs. Where heat energy is transferred from our legs to hands to warm it up. Thus here temperature is given to a colder part from a hot part.

This is an example of heat transfer hence, our legs cools down because some of its temperature is lost to hands still the overall temperature of the body remains balanced.

To find more about heat transfer, refer the link below:

https://brainly.com/question/13433948

#SPJ5

Answer:

hahahaha the soappp is dirty and the floor gets clean

Answer:

I appreciate you- owo... and people do love you. uwu. even tho I am a stranger I love you :D. ❤

You're the best person anyone could ever ask for. Trust me you're enough <3

Answer:

they all have the same ionic charge.

Explanation:

Alkaline earth metals are group 2 metals on the periodic table. They are divalent elements because they have two valence electrons and ionize by donating these two valence electrons. Elements in this group have the same numbers of electrons in their outermost shell of their atoms. i.e. they all have the same number of valence electrons and ionic charge.

Answer:

ZnSO4

Explanation:

There

Answer:

Explanation:

The new pressure can be found by using the formula for Boyle's law which is

[tex]P_1V_1 = P_2V_2[/tex]

Since we are finding the new pressure

[tex]P_2 = \frac{P_1V_1}{V_2} \\[/tex]

From the question we have

[tex]P_2 = \frac{598.9 \times 675.6}{235} = \frac{404616.84}{235} \\ = 1721.773787...[/tex]

We have the final answer as

Hope this helps you

Answer:

See explanation

Explanation:

The thermal energy of a substance is affected both by its mass and by its temperature. Thermal energy is defined as the total kinetic energy of all particles in an object.

Even though the cup of water has a higher temperature, the bathtub has more thermal energy because it contains much more mass of water compared to the cup. It will release more thermal energy to the surroundings compared to the cup of boiling water.

The bathtub of warm water has a higher total thermal energy due to its bigger volume, but the cup of boiling water has a higher average kinetic energy per particle.

The thermal energy of a cup of boiling water is greater than that of a warm bathtub. The sum of all the kinetic energies of the particles in a substance is its thermal energy. The temperature of boiling water is higher than that of warm bathwater. The average kinetic energy of the particles is measured by temperature. The average kinetic energy of the particles in a cup of boiling water would be higher than that of the warm water in a bathtub, which is normally between 38 and 45 degrees Celsius (100 and 113 degrees Fahrenheit), because water has a boiling temperature of 100 degrees Celsius (212 degrees Fahrenheit).

To know more about thermal energy, here:

https://brainly.com/question/3022807

#SPJ6

Answer:

Newton's 2nd Law

Explanation:

Newton's Second Law of Motion is concerned with the effect that unbalanced forces have on motion.

Law of unbalanced forces is also know as Newton's 2nd Law

Answer:

Since salt ions are heavier than water molecules, seawater is denser than freshwater. The density of seawater ranges from 1020 to 1030 kg/m 3 while the density of freshwater is about 1000 kg/m 3. Variations in salinity also cause the freezing point of seawater to be somewhat lower than that of freshwater.

Explanation:

Answer:

b

Explanation:im not really sure sorry if its wrong

im pretty sure its C, if im right please give me brainlist

The function where the bones of the skull mainly perfom should be that they protected the tissue and organs.

Here the tissue and organs should be considered as the basic structural units with respect to the bodies.

Here the tissues should be comprise of the cell collections that have the same kind of function while on the other hand, the organ should be the tissue collections.

Therefore, it protected the tissue and organs.

learn more about tissue here: https://brainly.com/question/19031918

Answer:

(c) by increasing it's mass

Answer:

(C) by increasing its mass

Explanation: Mass and velocity are both directly proportional to the momentum. If you increase either mass or velocity, the momentum of the object increases proportionally. If you double the mass or velocity you double the momentum.

Explanation:

What type of graph is most appropriate to present the data in Table 4? Create a graph of the data in Excel or another graphing software and submit it to your instructor.

Develop a detailed hypothesis for your experiment.What would your experimental approach be to test this hypothesis? Be detailed in your description of the experiment.

6.What are the independent, dependent, and controlled variables in your experiment?

What type of graph would be appropriate for this data set? Why?

Answer:

C. 3,2

Explanation:

these coefficients balance out the equation.

Answer:

deposition I hope this helps!!

Explanation:

Answer:physical weathering

Explanation:

Answer:

you would need to multiply 50 times 2 wich is 100 so i beleive its 100

Explanation:

Answer:

Electrical energy

Explanation: Kinetic energy is motion, it is the motion of waves, electrons, atoms, molecules, substances, and objects. Electrical energy is the movement of electrons.

Answer: Electrical Energy

Explanation: The movement of electrons is Electrical Energy, because Educere says so :)

Answer: I believe it is the number of protons.

Answer:

[tex] P_{2}) = 0.6 \; atm [/tex]

Explanation:

Given the following data;

Initial volume = 400 mL

Final volume = 2000 mL

Initial pressure = 3 atm

To find the final pressure P2, we would use Boyles' law.

Boyles states that when the temperature of an ideal gas is kept constant, the pressure of the gas is inversely proportional to the volume occupied by the gas.

Mathematically, Boyles law is given by;

[tex] PV = K[/tex]

[tex] P_{1}V_{1} = P_{2}V_{2} [/tex]

Substituting into the equation, we have;

[tex] 3 * 400 = P_{2}* 2000[/tex]

[tex] 1200 = 2000P_{2}[/tex]

[tex] P_{2}) = \frac {1200}{2000}[/tex]

[tex] P_{2}) = 0.6 \; atm [/tex]

Answer:

Give them each one so all of you is 8

Explanation:

I hope it helps:)

Fred and Florence have a combined total of 14 markers. Meaning, the amount of markers between all three is 24. If Maggie gives one marker to Fred and one marker to Florence, then each of them will have 8 markers.

Answer:

C) low ionization energy and low electronegativity

Explanation:

Answer:

heterogeneous

Explanation:

composition is not uniform through out

my mom !!!Explanation:

Musscle man

I think it is

K2SO4?

Answer:

1 And 2 are soluble in water

Answer:

the answer is 11

Explanation:

Ok, let us understand what is an atomic number, an atomic number is simply the proton number, the atomic number is always seen at the bottom left corner in a element of a periodic table, it is the number of proton in a atom of a certain element.

Answer:

Well, it could be B or D but I would say B.

Explanation:

The structure of an organelle is usually fit to its function so it is most likely B.

Hope this helps!